I have a LeClerc Mira model, older style. I was having problems keeping good tension so I bought the brake conversion kit from Camilla Valley Farm. While this has helped some, my brake drum will STILL rotate a little bit when I use my ratchet and pawl system on the front beam to tighten my warp! I know I am not supposed to need to use the friction device on the left to help with my warp tension but if I have the friction device screwed all the way down then I can achieve a tighter tension.
I had previously posted about this issue and I looked into several of the suggestions. The problem is when I try to get my threads real tight by using the ratchet and pawl on the front beam the brake drum on the warp beam actually rotates a little bit causing me not to get a super tight tension.
Now, about the amount of tightness on the warp. Maybe I am putting too much tension on my warp?? If I can get a it a real tight tension then my boat shuttles runs into all my threads in the shed.
So is this a tension issue or am I trying to achieve too tight of tension. Either way it seems that my NEW brake drum and brake circle should not move when I tighten tension on the warp.
Thanks for any input!
New Brake Conversion
Ratchet and Pawl on front beam
Brake Drum and Brake Circle. This is what rotates (only when wanting high tension) when tightening my warp.
Friction device on left side.(Warp beam advance control system)
Comments