I just purchased a vintage Rasmussen 24in 4s table loom. It has heddle bars, not frames, that are tied to the lams/levers, and can be adjusted. It came with 81/2 in flat steel heddles, which are rusty and need to be replaced. On the loom reviews sites, many comment on the fact that these looms had a good shed.
My other looms ( both floor looms) use 91/2 in heddles and I have a good supply of extras.
My question is, if I change the heddles to the longer ones, how will that affect the shed? I know I will have to tie the upper bar an inch higher. I have tried to figure this out before I replace all, warp, and find out the shed is too small. Is there an advantage to having shorter or longer heddles?
Also, this loom, like some other table looms I have seen, has pegs to allow the beater to be in two positions, different distances from the breast beam. Why would I want to position the beater either closer or further from the beam?
Thanks in advance for help.
Comments