I just purchased a vintage Rasmussen 24in 4s table loom. It has heddle bars, not frames, that are tied to the lams/levers, and can be adjusted. It came with 81/2 in flat steel heddles, which are rusty and need to be replaced. On the loom reviews sites, many comment on the fact that these looms had a good shed. My other looms ( both floor looms) use 91/2 in heddles and I have a good supply of extras. My question is, if I change the heddles to the longer ones, how will that affect the shed? I know I will have to tie the upper bar an inch higher. I have tried to figure this out before I replace all, warp, and find out the shed is too small. Is there an advantage to having shorter or longer heddles? Also, this loom, like some other table looms I have seen, has pegs to allow the beater to be in two positions, different distances from the breast beam. Why would I want to position the beater either closer or further from the beam? Thanks in advance for help.

Comments

sequel (not verified)

If it's a jack loom, the heddle eyes at rest need to be below the back and breast beams, about half the distance between the heddle bars and the heddle eyes.  If it's counterbalanced, the heddle eyes need to be positioned so the warp goes in a straight line from back beam to breast beam.  The size and geometry of your loom will tell you if the longer heddles will work or just bang into other parts of the loom.

Michael White

If you got the 9.5 inch heddles try them to see if they will work for you. If not I sell 8.5 inch eye heddles. About the beater, the sweet spot when beating is when the beater "hits" the yarn at a 90 degree angle. So some looms have a moveable beater to allow the weaver to find this spot.

Michael

Georgia Yarn Company

Swampweaver

Thank you both for the help. Michael, will certainly contact you if I need the 8 1/2 in eye heddles. I am down here in the Okefenokee, and guess you may be my closest "local" yarn store :)

Josephs Coat

A table loom is neither a jack nor a counterbalance. I suppose technically it is closer to a jack, since the harnesses lift independently and only in one direction. So the eyes should be lined up below the breast and back beams ?

Submitted by Swampweaver on