There's probably a name for these grograin ribbon connectors, but I don't know it.  Anyway, after 30+ years, one of the grograin ribbons that is stapled to the warp beam and holds the steel warp rod on the other end seems to have stretched.  We're going to restaple it so that the warp rod is parallel to the warp beam.  It occurs to me that I need to check that the breast and warp beams are propeerly parallel before we staple. 

  • Anything else I should check first? 
  • Any ideas why (esp. only one out of 8 ribbons)? 
  • I've replaced one of the steel rods because it warped; would the uneven ribbons cause it to warp?

(Don't know if you can tell that the warp rod is uneven in the picture...)

 

Comments

Joanne Hall

When you are not weaving the full width of the loom, you need to take off the ribbons which are on the ends.  If you  leave them on, the bar will bend, whether it is metal or wood.   If all the ribbons are left on when a narrow warp is used, the center ribbons might stretch as that is where the tightest tension is.  Is it a center ribbon on the cloth beam which is stretched?

Joanne

Joanne Hall

Most looms would have four, five or six of these ribbons, or beam cords.  How many are on your cloth beam?

Joanne

kfsuko (not verified)

4 beam cords per beam.  And it's an outermost one that's stretched.  Thanks, Joanne - I had no idea the unused beam cords should be untethered.  Learn something new every day!

Submitted by Anonymous (not verified) on