There's probably a name for these grograin ribbon connectors, but I don't know it. Anyway, after 30+ years, one of the grograin ribbons that is stapled to the warp beam and holds the steel warp rod on the other end seems to have stretched. We're going to restaple it so that the warp rod is parallel to the warp beam. It occurs to me that I need to check that the breast and warp beams are propeerly parallel before we staple.
- Anything else I should check first?
- Any ideas why (esp. only one out of 8 ribbons)?
- I've replaced one of the steel rods because it warped; would the uneven ribbons cause it to warp?
(Don't know if you can tell that the warp rod is uneven in the picture...)
Comments