merrymac (not verified)

Thanks so much, Laurie.  I went up and checked.  I did thread correctly - just typed incorrectly.  However, I had learned that "a" - treadle 1 and 3 - was always thrown from right to left ... "b" - treadles 2 and 4 - were always thrown from the right.  Soooooo .... that's what I have been doing.  This is incorrect?  Am I understanding correctly? 

I have treadled three times, 2 times, wherever the draft said to do that.  So at least I believe I did that correctly.  :)

I was not aware about the numbering system in overshot re: even and odd.  Thanks so much for that info.

I'll retie and see if I can get the pattern going correctly with your suggestions.

Thanks so much.

God bless.

MerryMac

merrymac (not verified)

Laurie, you were very, very correct in wondering about my threading correctly.  I had places where I swapped what should have been thread 2 for thread 4!!!!!  I haven't a clue where my mind was going to cause that.  Anyway, not only did I do that, I also missed totally one entire 8-thread section in warping! 

Well, duh!  I have refigured my threading - correctly, I hope and am in the process of rethreading the entire 330 thread warp.  That just teaches me to be more careful in writing the draft down plus checking my figures before threading.  Lesson learned.

Thanks again for your help. 

God bless.

MerryMac

claudia (not verified)

 Absolutely gorgeous.  I am holding on to some JOY yarn that was a gift.  This is my inspiration to warp it up and start weaving.

Claudia

Deanna (not verified)

I had heard of this from a local weaver.  Does it hold the yarns well, I usually use a very tight surgeons knot so that the threads do not slip.  This might be an easier way and a faster way.

feltedbag (not verified)

I recently learned about using loopers to tie my warps and it works very well -- my threads don't slip.  And it's easy on the hands.

merrymac (not verified)

Since learning about using the loopers to tie my warp threads on the warp board, I have found myself reaching for loopers for other needs on the loom.  When misthreading, I have used the loopers to "tie" adjacent threads together on each side of the misthreaded threads - to keep them out of my way when fixing the problem.  I've used the loopers to tie my "sets" together when threading the loom.  This way, if I lose track of my threading for whatever reason, it is easy for me to see where I left off?  (For example, if there are 12 threads to a pattern, I "tie" the 12 threads together with a looper as I'm going along.  Easy to put on, easy to pull off?)

Off hand, I can't remember any other specifics that I've used them for ... but just about any time you need to tie a knot - or use thread to track something, a looper can be utilized.  No having to untie the knot later on?

Hope this answers your question.  I'm sorry but I am not familiar with a "surgeons knot"?  Where I do have to have a knot, I typically do a weaver's knot or a square knot?

 

snaseman (not verified)

What is a pot holder looper and where do I find these?

feltedbag (not verified)

You can usually find them in the kid's toy section at places like Target.  Here's some on Amazon.

Potholder Loopers

lkautio (not verified)

What yarn, sett, and ppi are you using?

Laurie Autio