I have a Herald jack loom that I bought used. The warp beam is 8 sided, and had small staples holding what appears to be stout linen cord, which was connected to a 1 inch by 1/2 in stick. The staples have pulled out and now I need to re-do the entire setup. I have linen cord that looks exactly like the cord used, but how should it be attached, and is there a way to be certain that everything will be exactly the same length, etc? MIght be a dumb question, but my other loom has the cloth apron on both beams, so I'm just not sure how to proceed.
Thanks in advance,
Deb in N TX
Comments