I have a Herald jack loom that I bought used.   The warp beam is 8 sided, and had small staples holding what appears to be stout linen cord, which was connected to a 1 inch by 1/2 in stick.  The staples have pulled out and now I need to re-do the entire setup.   I have linen cord that looks exactly like the cord used, but how should it be attached, and is there a way to be certain that everything will be exactly the same length, etc?    MIght be a dumb question, but my other loom has the cloth apron on both beams, so I'm just not sure how to proceed.

 

Thanks in advance,

Deb in N TX

 

Comments

Michael White

You could put on a cloth apron at this time if you like. If not you can replace the old cords with new ones by making a small jig with nails the length that you want. Hold one end wrap around the nail an come back to the start. Staple the two loose ends leaving the loop to attach to stick with lurk head knots.

Michael

sequel (not verified)

My Herald, and all that I've seen, has canvas belting attaching the warp beam and the warp stick.  These are stapled onto the x-shaped solid warp beam and extend out to the stick.  My beam has convertible sectional rakes as well that enlarge the warp beam to a full yard circumference - smooth or sectional.  I'm guessing your "apron strings" have been replaced, so you get to do whatever you want when you replace them!

Submitted by Anonymous (not verified) on