Posting pictures for this here as peple are finding it hard to locate them on the other  busy threads.

 

                                     

Place a second dowel under the weaving.                             Roll the two dowels up together. Place the

                                                                                                         backstrap cord OVER the first dowel and around

                                                                                                         the second one. It doesn't matter which dowel ends 

                                                                                                         up first or second.

 

Now you can continue weaving. (Please excuse the rather un lady-like sitting position here!!!!)

This is shown in the video segments in the WeaveZine article that I wrote on Backstrap Basics.

weavezine.com/content/backstrap-basics

Laverne

Comments

Aquinnah (not verified)

 I have now tried this method and it works a treat, though for some reason I find I need to roll up more than I actually want, as some of the roll gets 'lost' when I hook myself up and start weaving.  

mischiefmanaged (not verified)

OK, I am starting to get a complex. I got going at last on my first backstrap piece. I followed these directions for rolling it up and it keeps unrolling! Argh!! (I also tried doing it the other direction with no better results). Any suggestions? Cindy

bolivian warmi

Hey Cindy,

How far along are you? If you are just beginning, I think you might be overlooking one crucial piece of information because all I can say is this works! I never have any problem with this.

Are you sure you have the extra stick UNDER your work and are rolling under and away? Are you sure that you are putting the straps from your backstrap OVER the near stick and around the far stick?

If you are far along-like almost finished-and your yarn is heavy and you have alot rolled up then I can understand it not working.

This system stops working if you are using  thick yarn with a narrow warp and have rolled up A LOT of work-I made a bag strap with 12 wpi cotton and had about 30 '' rolled up. It doesn't work in that case and you have to use another system. This is the only time this has happened as I usually don't work with this weight of yarn.

This is what I rigged up to weave the last bit of band. You can see that there is a lot rolled up.

   

Roll up with 2 sticks.                               Place a 3rd stick under weaving.         Position 3rd stick as shown. 

 

                                  

Place straps over 1st stick and around                              Lean back-it won't unroll.

the 2nd and 3rd.

NOTE ....You have to overroll it to start with so that the weaving line ends up close to you. I also lengthened my backstrap strap just so I could take these photos.

I hope you figure out the problem. Let us know.

mischiefmanaged (not verified)

Thanks again for helping, Laverne. I was close to the beginning when I wrote because my piece was unraveling all the way. I tried again after reviewing your pictures and still couldn't get it to work all the time. Then I tried with a smaller 2nd stick (I had been using a larger diameter one as my 2nd one just cuz it was there in my pile). It worked right away when the sticks were of the same size. So it was either that or I somehow tied it differently then. Go figure. Made lots of progress after I could actually reach my weaving (grin).  Cindy

bolivian warmi

Good to hear! Actually that is a handy tip and something worth noting-sticks should be same size. I have never thought about that. You will save someone else some grief. :-)

Laverne

Submitted by bolivian warmi on