Weaving newbie here. I have a Kromski Harp and am having trouble keeping the warp length/tension consistent as I warp the loom.

When I'm using the warp helper rod on my Kromski Harp (25"?), as I warp across, the warp starts pulling the helper rod inward, so that by the end of the warping process, the part of the warp where I started is longer/looser than the part where I ended. I think this is because the rod is only held at one end.

Does that make sense? Has this happened to anyone else? Does anyone have suggestions for keeping this from happening?

Susan in CT

Comments

quejimenez (not verified)

 hi susan,

i have a harp 32", and i'm wondering if i can help...although i don't know what the warp helper rod is...i'm very new to weaving too...just finished my first project on my harp.

are you using the full length of your harp (the whole 25") or are you doing something smaller?

i did notice that one of my rods did bow in where the warp was wound on...but i didn't have any issues with the tension besides having to tighten things up a bit as i went along.

i also did notice that the tension was lighter at the bottom end of the warp...the section closest to me as i'm working...and got tighter as i progressed up the warp. i hope that makes sense.

maybe someone else with a little bit more experience can help...claudia also has a harp..the same size as you i believe she'd be an excellent person to speak with.

debmcclintock

 Are your pegs pulling in as you wrap your warp bouts?  That might make uneven tension?  Push your rounds down to the bottom of your rods to keep the tension in one place.  Deb

sandeleh (not verified)

I use the warping helper all the time on my Ashford RH and I dont apply any tension to the warp until all of the slots are sleyed and I wind on my warp.   I think the warping helper probably works best with the indirect method of warping and that you are probably trying to use it with direct warping.  You shouldn't have any problems if you are not putting tension on the warp, but you can't do that using direct warping. 

Hmmmm...  What if you were to attach your apron strings to the warping helper dowel as you warp, thereby letting the loom bear some of the tension?  As long as your pawl is firm in the rachet the apron string should hold the warping dowel even.

I don't direct warp cuz I don't have a level place big enough to do it - I always wind my warp on my reel and then sley thru the slots and drop the loop over a long helper dowel, then once I'm done I move the warp loops to an apron rod that will fit the loom (I have a 24" loom, I use a 36" dowel with the helper, then move the warp to an apron rod just barely longer than the width of the warp on the loom). 

Let me know if this doesnt make sense or if you need more help.  :)

Sande in Fresno, CA, USA

Submitted by Anonymous (not verified) on