I finally got a Voyager 8h table loom for sampling and have been playing with it this week. I am finding the hand manipulation of the sheds time consuming and a bit tedious. Is it just because it's new to me after years treadling or is there a trick I'm not getting ? 

Comments

laurafry

Lever looms are always slower than a treadle loom. What you loose in efficiencies, you get in versatility.... Cheers Laura

sally orgren

Compared to foot-treadle weaving, yes, it will be slower. Compared to side-lever table looms, it is also slightly slower.

But you don't have to flip all the levers up into the resting position before lowering the next ones you need. Depending on the pattern, sometimes it is pretty easy to "walk" the specific levers, only manipulating the select ones up or down as you go. This works great with twills.

Use two hands. (I have an 8 and a 12 shaft Voyager. Yes, more levers than fingers. ;-)

Also, think about weaving the draft upside down, so you are lifting fewer levers. (Imagine what you do if a threading would be too heavy for your feet to lift on a floor loom.)

I don't know if you opted for the swinging beater or the regular beater. I think the swinging beater would slow me down more.

Practice also makes it go faster. I am pretty fast on these little guys, but then I weave a lot on them, too. I'll do short projects (no longer than 5 yards), but mostly use them for sampling and workshops.

Submitted by Peg R on