So I have been planning a project on my 8H 10T old Harold Jack Loom and I have only made a few things on it since I got it last year year. However, this projects has 490 ends, much more than other projects I have done. I was getting ready to thread and started to count the heddles and I was way short. Remembering that the loom came with a ton of heddles that I put in a drawer (and thank goodness actually found upon remembering), I proceded to add in the left overs. The question is, is there an average number that in general you should have per heddle upon set up or a reccomended number per harness I should have? I put enough for my current project plus a few more to make about 130 on each. Opinions welcome.

Comments

louiseinoz

It all depends on the projects you want to do and the thickness of the yarns you are using. If you're using a straight draw - 1,2,3,4,5,6,7,8 - then you will need about the same number on each harness. If you use a draft where every second end is on harness 1, then you will need many extra heddles on harness 1. If the next project takes up most of the width of the loom and doesn't need lots of heddles on harness 1, then you might find that there are so many heddles at each side of harness 1 that they push against the outside warp threads. Bottom line is that unless you just keep weaving much the same thing for every project, you will need to move heddles around regularly. It's a really good idea to calculate the number of heddles for each harness for the project you're doing each time and move them around if needed before you start as depending on how the harnesses are attached, it can be much easier to do it before the loom is threaded. I know that with my counter march loom, I need to have the right number on the right hand side before I start as I can't add extra in the middle as I thread from right to left but I can add extra on the far left hand side if I need to

ReedGuy

If your doing a lot of twills on 4 shaft looms, many times the most heddles used are on shafts 2 and 3 since the turn point is on 1 and 4. If doing plain weaves or block weaves the heddles are more evening distributed on the shafts. All you have to do is look at your draft and the repeat, count the ends per shaft and plan your heddle distribution.

Queezle

And if you are like me, and so anxious to start that you don't plan ahead well, all is not lost.  I am putting a summer and winter sample on my loom (fairly wide, 10 inches, at 30 epi).  Summer and winter uses a lot of heddles on shafts 1 and 2, and at about 80% of the way through threading the heddles, I noticed I had not left enough on the left.  Like you, nutmeg, I had some extras stashed away,  and was able to add them without disrupting the threaded heddles.   BUT I am now devising a scheme to keep a heddle count so that next time, I can adjust before threading.

thenutmeg2000

so far. I am a planner and always count heddles on each harness before attempting to thread. I usually do overshot but lately I have enjoyed some undulating twills and dornick twill. This pattern is Huckaback. I was just wondering if there was a suggested number that you start with in general (say I got a loom straight out the box and I was setting it up but then I thought about that aspect and it depends on the width and how fine I like to weave) but I see how it could make since to move them around at times, just as I discovered I usually have to change my treddle tie ups occassionally to suit a pattern. Sometimes I use 4 harness and sometimes the whole 8. So, I guess in thinking out loud I see the point of "it depends"...

Submitted by thenutmeg2000 on