Hi!  I'm new to weaving, just starting to teach myself and repair my loom.  I had a question about  maximum warp length on the loom, how can you tell how much you can fit max?  I have an old Harrisville 4T4H.  Say I want to make 4 1/2 meter projects, but I'd like to make as much as possible on one warp, how would I know my limitations?  I have a warping mill so I think I can fit more than I could on a warping board (if I am assuming correctly).    Thanks!

Comments

SallyE (not verified)

You didn't say if this is a floor loom, but I assume it is.  How long a warp you can get on it depends on how far the warp beam is from the back beam, and what kind of packing you use.   In reality, the only looms that are seriously limited are table looms because the diameter of the warp along with the packing builds up.

As a beginning weaver, you should be doing warps that aren't too long anyway.  In terms of learning it's helpful to go through the warping process several times, and a really long warp makes for a lot of time between warping experiences.   So start with 4 - 6 yards and see how it goes.   That will give you a pretty good idea of the loom's limits.

And welcome to weaving!

 

sally orgren

I'd say wind and dress the loom with several 2-3 yard warps. If you get into trouble, there are fewer consequences with a short warp. Then increase to 4-6. Long warps for most handweavers fall between 6 and 8 yards. Production weavers will wind 20 yards or more. Also, if this is a new-to-you but used loom, I would definitely put a short warp on it at first to test the overall working of the equipment. Good luck!

ReedGuy

tanukitextiles, as a new or beginning weaver, short warps will be more rewarding for now. You will want to explore fibres and structure by doing multiple projects and develop your techniques. If you start out with a very long warp, it will become an albatros because of all that weaving that has to be done, all the pitfalls your bound to encounter from lack of experience, while your mind is thinking about other projects by the time you have 5 yards woven. My intensions for a loom was to weave blankets, boy did that change. I have gone though lots of structures and still going, plus exploring how fibres behave singly and interact with different types. Don't enslave yourself with your first loom project. :)

tanukitextiles

Thank you for all the responses.  My first couple projects are going to be pretty small, kitchen towels and maybe a scarf :)  I just wanted to know how I could tell what my loom "potential" was when it comes time to warp a long one.  

Sara von Tresckow

Generally, you can put more warp on your loom than the clotoh beam wiill hold.

When you gain experience and go for a longer warp, you probably will need to cut the fabric once or more because the finished cloth will be thicker than just the warp.

Submitted by tanukitextiles on