Hello I am very new to weaving and put a very narrow ten inch warp on. On a few treadles I get a clean shed. If I push down on the tops of the shafts it will give me a clean shed. This makes me think I have tied wrong. I tied with ropes all even lengths to the spot on the pin directly below the lam. I am completely lost and frustrated. Any help would be appreciated. Thank you

Comments

sequel (not verified)

Assuming you have a counterbalanced loom:

If all your ropes are even, are all your shafts even?  A clean shed means all the threads are rising/falling together.  An even shed means the shafts are rising and falling from and to level positions. 

On the Colonial I have access to, the ropes on the pulleys sometimes fall off the ends of wooden rods to the metal parts they rotate on, causing an uneven shed. 

A narrow warp on a wide loom can be a problem if the shafts are unbalanced... are all your extra heddles shoved to one side?

Is the back beam in the right position?  LeClerc looms use the same parts for many different looms.  The side bars that support the back beam are notched or drilled in several places.  Use the one that puts the back beam at the same height as the front beam.  The warp should be in the center of the reed when at rest.

If your problem is not being able to get a clean shed, some warps not entirely up or down, look at which shaft is misbehaving.  Make sure the tie up cords are not catching on adjacent lamms.  Of course, you did check for crossed threads between the heddles and the reed, right?  Also, did you goof and put a warp through heddles on two different shafts?

 

 

 

sequel (not verified)

Assuming again you have a counterbalance loom... you know, of course, that on a counterbalanced loom, you need to be treadling two shafts against two others.  That is to say, if you tie up only one shaft to one treadle, it will rarely give you a clean shed.  You can manage it, like you said, by slapping it around a bit.  But these looms are designed to have two shafts countering two others.  If the shafts are tied directly to one treadle each and you step down on treadles two and four, then shafts two and four go down and one and three go up.  If you tie two and four to one treadle, then when you step on that treadle, the same thing happens...

Sara von Tresckow

Counterbalanced looms do NOT need to have the same number of shafts moving up and down. It is more difficult, true, but that does not make if impractical or impossible.

Laila Lundell's "Big Book of Weaving" shows tieups for any number of shafts between 2 and 8 as well as diagrams for sheds that form, for instance 3/1 twill.

Bethylynn

Hello and thanks for the help. I did indeed have that side bar backwards and in the wrong hole. I have a colonial in counter balance. I finished the warp I was working on. I noticed some very sticky heddles as well and some trouble when treading the fourth pedal. Would you mind terribly if I got back to you when I get another warp on? Thanks

Joanne Hall

When you are putting on your next warp, you might want to replace the treadle cords with Texsolv cord and arrow pegs.  That way they will be adjustable in length.  You will find it more comfortable if you have longer treadle cords.  And, it might even give you better sheds as well as make the treadling easier.  Your loom is made to be both jack and counterbalance.  The treadle cords for the jack version need to be shorter than the counterbalance.  But they only give you the short ones for both.  Longer cords would be better.

Joanne

Submitted by Bethylynn on