Recently I put some files on our website to help weavers who have a counterbalance or countermarch loom.  I wrote these files to help weavers who have acquired a used loom.  The first file is an introduction.  Part 2 is on counterbalance looms.  Part 3 is on countermarch looms.  If you have one, or are curious about them, you may find these files very informative.  It includes information on Texsolv heddles and tie-up cord.    The link is on our home page menu, counterbalance and countermarch looms. 

http://glimakrausa.com/about-cm-cb-looms.html

Joanne

 

Comments

texaspaintbrush (not verified)

I am new to the counterbalance world and am weaving my first rug. I am having a problem that shafts two and four sink on the right side while weaving, but are level when they aren't engaged.  This occasionally caused the harness chains to fall off as there is too much slack. What should I adjust on the treadle/lamm tie-ups?  The weaving seems fine, but having to reconnect the harnesses is a bit of a drag and I know it needs adjusting, just don't have enough experience to know what is wrong.

Many thanks,

Lisa

Joanne Hall

Hi Lisa,

It must be an older loom, since the Cranbrook looms started as counterbalance, but then changed to be only countermarch.  A warp wide enough for a rug usually is not a problem, unless you have a really wide loom and a narrow rug. Take a look at the files I put on our website.  The link is in the first message. Then let us know what you think the problem is.  The first thing that comes to mind is that you should try using the center treadles.  But let us know if you find out what the problem is.

Joanne

KarenIsenhower

I read through the new PDF pages that you posted. Thanks so much, Joanne. It really helps as I keep learning about countermarch looms. I especially like the "Order for warping and tying up your loom." It's exactly the checklist I needed to make sense of things!
Submitted by Joanne Hall on