Hello,

I am going to be the lucky owner of a Mira 4shaft table loom within the next 2 to 3 weeks, but I have not been able to find anything on it?

It is definitely not to be confused with the Leclerc Mira loom.

Does anyone have any ideas about it?

Also, I have downloaded the dvd of Warping your Loom.

However, I am not sure, for a first plain weave project, how to thread the heddles on 4 shafts. Should I just put the heddles of two of the shafts aside and then thread alternate heddles on shaft 1 & 2, or is there a way to use all 4 shafts?

Thanks for helping a newbie out!

Comments

Claudia Segal (not verified)

Congrats on the loom!  How exciting.  

For plain weave on a four shaft loom you can use all four shafts and treadle shafts 1 & 3 together and shafts 2 & 4.  If you are threading for plain weave you thread the shafts 1,2,3,4 or you can go 4,3,2,1.  Here is a draft.  I have marked the four parts of the draft in case you are not familiar with reading drafts.  You might find Peggy Osterkamp's Learning to Weave book helpful or Debbie Chandler. 

Hope this helps you out.  There are tons of drafts for plain weave on 4 shafts at handweaving.net or search on Weavolution.  Put plain weave in the search box at the top of the page and use the drop down menu to search on drafts.

Oliveandoaks (not verified)

Dear Claudia,

thank you very much, this is helpful.

However, I do not think I will end up having to sort out tie-ups, since it is a table loom and I will have to manipulate the individual shafts with levers.

So, I either raise shaft 1&2 and for the next pick I raise shaft 3&4 for plain weave. I hope I understood this correctly.

 

Claudia Segal (not verified)

If you are doing plain weave and the loom is threaded with one thread on shafts 1-2-3-4 in that order, you raise shaft 1 and 3 and alternate 2 and 4 for plain weave.  The tie-up is useful on almost any type of loom.  You have four shafts and they each need to do something to create a shed for the weft.  So, to weave pw you alternate 1 & 3 with 2 & 4.  For a twill you weave 1 & 2, 2 & 3, 3 & 4, then 4 & 1.  That's the difference.

Do you have any beginner books?  Have you found the Weaving 101 group?  Both might be more helpful than me.  Keep asking, no question is a dumb one.  Learning is work and learning to weave is fun, in mho.

Claudia

Oliveandoaks (not verified)

Dear Claudia,

 

thank you! I was halfway there. So, alternating shafts for plain weave, neighbouring shafts in sequence for twill....got it!

Submitted by Anonymous (not verified) on