Hey there

I purchased several boat shuttles with my vintage floor loom.  Some are open-bottomed and some are closed.  What are the pros and cons of each?

Thanks!

Candace

Comments

Alison (not verified)

One of the pros of the open bottoms are that they weigh a bit less.  I suppose a con would be that if you over fill your bobbin, it could increase the friction.

Joanne Hall

There are many different shapes and sizes of shuttles for different purposes.  But, it would appear to me that the open bottom shuttles would be easier to make.  And the open bottom ones are usually the larger and longer shuttles, which have a larger opening for the quill.  Perhaps in the larger shuttles, the wood might eventually crack if the shuttle did not have an open bottom.

Joanne

Michael White

I have also heard that one of the reasons for the open bottom was to give better control-you could put your finger on the bobbin as it exits the warp and have a better feel.  Personally, I have both, and prefer the closed ones that I have.  One point that I did learn and it is important.  If you use the plastic bobbins, they are different, and what fits a Leclerc shuttle will not necessarily fit a Schact for example.  I have tried and it can be aggravating as the bobbin grabs on the sides and does not run smooth.  If you use quills this would not be an issue.  Best bet is to try them out and see what you like-I think this is one of those weaver preference things.  Even in the boats with closed bottoms that I have, I still seem to have favorites, ones I reach for consistently and others that only get a work out when I need lots of shuttles.And we haven't even got to end feed shuttles!!!

Happy Weaving

Cheryl

naturalfibres (not verified)

I have two Schacht open bottom shuttles which are my "go to" shuttles.  I find I'm able to control the weft much better with them, but as Michael mentioned my LeClerc bobbins don't fit in them, so I put a small barrel bead at end each of the metal rod which keeps the bobbin from moving.

Joanne Hall

You might try small washers on the spindle, the diameter the size of the bobbin ends.  They work better to prevent the catching of the bobbin, without stopping the sideway movement, which is necessary for smooth unwinding of the thread.

Joanne

Submitted by celtinbirks on