The edge warps always tend to get slack.
What I do is....once I have my warp on the loom and have made my heddles etc.....I untie the start and end knots on the far end loom bar and re-tie those two warp ends a little tighter than they should be. You may need to get someone to help you by holding the near loom bar under tension while you untie and retie the knots at the other end.
If they get slack once you have progressed with your weaving, the easiest solution is to slip a dowel under those warps at the far end and tie the dowel to your far loom bar. I have kebab skewers that are really thin that usually do the trick and I have a collection of dowels of various thicknesses should I need something more substantial.
Other odd warps sometimes get slack for no apparent reason so it is handy to have the dowel at the far end to take up the slack on all those warps that want to misbehave. One kebab stick or thin dowel can solve the problem for all the loose warps at once.
Laverne
.jpg)
Using a thin dowel to take up the slack on the end warps. The thin dowel will then be tied to the loom bar to keep it in place.
Comments