There is no ''right'' way to put together a backstrap loom. Backstrap looms vary a lot in shape and form all over the world. I like loom bars of around 19'' length but I was reading a web page today that suggested 36''. Of course it depends on what width of fabric you are hoping to weave. The width of a backstrap woven piece is pretty much limited to how far you can reach from side to side to pass the shuttle. I have yet to weave anything wider than 12'' so 19'' bars are fine for me.

An easy way to see my own personal recommendations for putting together a loom is to read the artcile I wrote for weaveZine.       weavezine.com/content/backstrap-basics

Here are the basic parts........

Two of the 1'' dowels will be your loom bars. The third is used to roll up your work as you progress.

The flat stick serves as a sword-it will prop open the shed as you pass the weft. You can use it to beat in the weft too.

The two thin dowels will serve as shed stick and heddle stick. Often you will want a thicker stick for the shed stick depending on your project.

You will also need a shuttle-this can be easily cut from thick cardboard as seen below..

Many of the loom parts can be improvised from things you may have around the home or in the garden shed.

.

The backstrap can be a pillow case with cords knotted around the ends, a bag strap, legs from an old pair of jeans.

Many of our members have contributed their own ideas and improvisations of loom parts, backstraps and shuttles and we have a page here dedicated to that with photos, diagrams, explanations and comments. It is well worth reading to see all the posibilities for loom construction. Here is the link.........(look out especially for great DIY tips from Francorios)

www.weavolution.com/node/3381

 

Laverne Waddington

 

 

 

 

 

Comments

Loominaria (not verified)

How smooth do you like to have the loom bars and other pieces?  Is it good to make them as smooth as possible, or is it better to have a touch of grip to the finish -- or unfinish?

Carol Ventura's backstrap loom page said the loom bars and shed stick average 10 inches (25.5 cm) long for the Maya Hair Sashes. It seems like the backstrap would be falling off the ends often, unless the tie grooves are quite deep.

Sorry if I'm posting in the wrong place. There is so much here, it's hard to follow where to put comments and questions.

Kurt

bolivian warmi

Post wherever you like Kurt! We'll find it eventually!

The shortest loom bars I have are 12'' and they are part of a set that I bought in Guatemala. They have grooves and that helps. . I don't think I would feel comfortable with anything shorter-as you say the backstrap ties would be wanting to fall off. Mind you I haven't tried shorter sticks so who knows!

. I like my 19 inch sticks and I weave everything on those-even teeny 1'' bands. They don't have grooves because I haven't fellt the need for them. If you are tying up to a door knob or something like that where your loom bar will be ''floating'' you should have grooves or your ties will be slipping in toward the center of the bar.

My sticks just happen to be quite smooth-that's how they were when I got them or cut them from the broom. I think smooth is good. You don't want to be catching your warps on sticky bits but I don't think you need to go overboard with this. I use the broom handle as it comes from the store- just smooth enough so you are not getting splinters in your hands as you sweep. I suppose a shed stick that is super smooth will tend to slip about more but  yahoo! you know how to fix that problem now, right?

Laverne

 

Submitted by bolivian warmi on