I'm not entirely sure I'm posting this in the "right" place but hopefully, somebody will direct me if I need to change locations....
I have an 24 shaft AVL compu dobby I. The sectional beam has pegs, not the wire dividers. This is a fairly new loom to me and I keep thinking that there must be something I should do differently when I'm tying on the warp. I use a spool rack as the warp source and thread the ends through the tension box before tying to the warp cord.
Is anybody else tweaked by what happens when you wind on a beautifully tensioned warp ... OVER THE WARP cords? I've sometimes thought that I should replace the cords with a flat tape the width of each 2" section. Does anybody else think this is a problem? Any solutions out there?
Thanks for any thoughts on the subject.
Jeane
Comments