I am weaving honeycomb for the first time, and could use some advice.  I am weaving a two block honeycomb on four shafts, using 3/2 perle cotton.  I want the cells to be about 2".  My draft calls for an 8 warp end and 8 pick block, which at 14 epi, will not give me 2" blocks.  This will be used as upholstery fabric, and must be sewable.  Would I be better off to increase the size of the blocks, or to use the 3/2 doubled?

Comments

Queezle

I hate to say it, but I would put a sample warp onto your loom.  You are correct that the math doesn't work to give you a 2" block.  If it were me, I would make a warp with varying block sizes - from the recommended to your calculated 2 inch, maybe 4 blocks of each size.  And of course I would measure, then measure again off the loom, and again after wet finishing.  Personally, sampling always leads me to adjust my plans, and nearly all the time, my weaving is better for it.  Let us know how it looks; its been ages since I've honeycombed. 

ReedGuy

The problem might be in getting the float lengths a little long that go over the heavier weft. Try doubling the pick/warp in the cells and keeping the large weft to two picks and see how it wet finishes. If you get the cloth too open by spacing the warp it's not going to work well as upholstery. It has to be dense cloth. Long floats won't be good either. Drafts I see for honeycomb keep the cells no wider than 8 warps.

Is your warp 10/2, outline weft 3/2?

sandra.eberhar…

Reed Guy, that's why I'm asking for advice.  I'm trying to find someone who has tried larger cell sizes than the standard 8 warp/pick.  I can make it larger by doubling the thread, but that will make it hard to sew.

Queezle

I think the floats are all on the fabric's back, so if you are using this fabric for upholstry, it might not be a worry????

sandra.eberhar…

You are right, Queezle, the floats are all on the back.

ReedGuy

However, the warp floats are on the front over the large weft. They can get long between the cells where they join the heavy wefts from above the cell row to below them. They give the heavy weft the bends when washed forming the outlines. If you expanded the cells in width than the float length stays the same. But if you try in height they get longer. On the face. You see this even in Gagnefkrus.

Submitted by sandra.eberhar… on