Hi All, Need some help troubleshooting floating selvedges. I am borrowing a friend's Leclerc Meco table loom for a workshop. The floating selvedge is staying almost even with the warp (threads at rest when I lift harnesses to make a shed).  I use a floating selvedge most of the time, and haven't had this problem before.

I did beam the floating selvedge threads with the rest of the warp.

Any suggestions how to get the floaters to sit in the middle of the shed where they belong? I wondered about adding little weights, or putting something on the back beam to lift them higher.

Thanks, workshop is Monday.

Jerri in NJ

 

Comments

Sharon (not verified)

Using a well-twisted, non-hairy yarn tie a loop that goes around part of the castle and hangs down behind the reed but in front of the heddles.  Since you have already sleyed your floating selvedges, I would tie this loop around those threads so that the bottom of the loop is an inch or a little more above the warp at rest.  One of these on each side ought to do the trick.

trishSA (not verified)

I always wind my floating selvedges into my warp and weight them - they don't have the same take up as the warp so begin to get slack as time goes on. Are empty heddles on either side of the warp keeping your selvedges from popping up where they belong? Tie them back if that's the case. I love Sharon's loop suggestion also. Good luck! Trish

Jerri S

Thank you for the suggestions.  I was going to go for the rigging a higher spot on the back beam to raise the floater, but I am going to go with Sharon's loop idea. I actually re-beamed the warp, so took off the selvedges and weighted them seperately, which elicted no change. I am wondering if it might be the design of the loom.   :D Jerri

Submitted by Jerri S on