I recently decided I HAD to try rep weave.  After a few false starts, my mug rugs/samples turned out okay. 

But here's the thing...I would like to make more mug rugs, but I don't want to hem them.  I'd prefer to finish them with fringe.  How do I do that?  Sure, I can run a machine stitch along the start and end edges, like I did with my samples/mug rugs, but that doesn't get either the thick or thin weft secured.  How do I do that?  On loom hemming?  I could do that with the thin weft, but then how take care of the thick weft?

Thanks for your knowledgeable replies!

rep weave mug rugs/samples

Comments

theresasc

strips of cardboard as a spacer between each item, and then hem-stitched with the thin thread.  At the beginning, I threw 2 picks of thin, started the pattern, alternating thick and thin for about an inch, and then hem-stitched.  I did not worry about the thick, just used the thin at the beginning and end for a nice finish.  One thing to watch is to end on the same shed as you started so that the same ends are up on both ends of the item, that gives a nicer, more balanced finish.

Those are great looking little rugs!

sandra.eberhar…

I usually use rep for items that will receive hard wear so I weave a thin weft border and hem.  I have found that fringe does not wash well or wear as well as a hem.  I think if for some reason I wanted fringe, I would again weave the thin weft border and hem stitch.

Erica J

Great timing Peg. Thank you for asking this question, this has been very useful ahead of my own rep weave studies.

laurafry

Just cut the thick weft off, weave a few picks (3?) of plain weave with the thin and hem stitch.  It will be fine.  If the thick is made up of several plies, you can separate the plies and cut half of them off and return the rest into the same shed as the last thick pick.  

Laura

Peg.Cherre (not verified)

Thank you for your information.  I'll do some rep weave again soon!

Submitted by Anonymous (not verified) on