Hi,

I would like to weave a scarf out of cotton in this twill pattern from Handweaving.net.

Handweaving.net draft

The warp is 16/2 unmercerised cotton and the weft will be 8/2 unmercerised cotton. Since I want the repeat to be a little wider apart, I was thinking of doubling the threads in the warp.

What sett would be best for this case? I guess there are 2 parts to this. The first is doubling warp. Does that a require a denser sett? The second is the thicker weft. How would this affect the sett?

Thankful for your suggestions!

Wendy

Comments

kerstinfroberg

Doubling the 16/2 will make each "working end" similar to 8/2.

Considering the relatively long floats (7) I would guess some 7-8 working ends/cm (approx 28-30 ends per inch, I think) would be a place to start.

wendywebt

Thanks for your answer.

I will try that. I wasn't sure, if the sett for a doubled 16/2 would be "the same" as 8/2.

I might also try a variation of the pattern to make the repeat wider without such long floats.

Bonnie Inouye (not verified)

The reason for the 7-thread floats is to have maximum contrast between warp-emphasis and weft-emphasis areas. A scarf with this design will look like it has ombre stripes when seen from a distance. You can see it if you zoom out on the draft in weaving software.

You can get an ombre effect with areas as wide and as long as you wish if you limit the float length, with longer floats possible when you use more than 8 shafts. But the strong stripe of warp color (or weft color) will be less striking when you use shorter floats. With this kind of design, I would use as many shafts as available.

Bonnie Inouye

wendywebt

 

Thanks for the explanation. So the pattern will appear more like horizontal stripes and the diagonal stripes will only be visible up close, I guess.

I am looking for contrast, so I will stick to the long floats and I am looking forward to seeing the effects on the finished scarf.

I will weave this on an 8 shaft table loom since I don't have so many treadles on my floor loom...

Wendy

Submitted by wendywebt on