How many harnesses and treadles is it possible to use without the assistance of a dobby? Is there other use as the number of harnesses increases besides more complex patterns?

Thanks, Jo

Comments

Bonnie Inouye (not verified)

I have seen table looms with 16 and even 24 shafts. That means operating a lot of levers with your hands, but it is quite possible to do this. It just takes time.

There are some brands of floor looms with 16 shafts and 18 or 20 treadles. I have short legs and cannot reach the outer treadles while inserting a shuttle into a reasonably wide warp on one of those looms, but you might have longer arms and legs.

Are multishaft drafts really "complex"? It depends on your definition of complex. A 4-block profile draft might not look complicated. That design could be expressed as overshot (and some other structures) on a 4-shaft loom, as summer and winter on a 6-shaft loom, as blocks of double weave on a 16-shaft loom, or as blocks of 5-end satin on a 20-shaft loom. Having more shafts gives you a wider range of weave structures so you can choose the structure that best suits your needs for the cloth at hand.

Some designs and some weave structures need more than the standard number of treadles. Mechanical dobby bars or computer-assisted looms make it possible to weave drafts that have more than 24 treadles. It is much easier to change the tie-up with bars or on a computer. Loom-controlled imagery is another reason to use many shafts and not be limited by a rather small number of treadles.

Bonnie Inouye

laurafry

I have a 24 shaft lever loom. As Bonnie says, it is more time consuming to flip levers than generate a lift plan for a computer assisted dobby loom. It depends on your goals, budget and available space. The lever loom is narrower than my four shaft loom, but nearly as long. I can do more complex loom controlled designs on the one, but much more slowly than on my AVL 16 shaft loom with Compu dobby. Cheers Laura

sally orgren

for both a table loom (levers) and floor loom (14 treadles). 

ReedGuy

I won't be going beyond 8 shafts and 10 treadles. That is a lot of cords in itself for my liking. :)

mneligh

I like my 20 shafts just fine and don't use a dobby.  I do arrange my tie-ups so that I can easily remember the treadling order, and I never stop in the middle of a complex pattern unit, as it may be difficult to find the place.  If that has to happen, write down where you are, your last and next treadles until you have enough information to resume.  I would like 32 shafts.

Besides more complex patterns, more shafts allow you to do multiple weave structures in one piece, like switching between summer and winter and overshot in a single piece, or two or more overshot drafts within one piece.  They also allow you to break down your pieces into zones with independent structures, like saving 2 shafts for the selvages and using the rest for the main pattern (I like to do rolled edges on rugs so I make wide selvages.).

On warp-faced structures you can move warp threads farther apart, decreasing the tendency for them to stick together, even if those shafts act as a single unit.

Submitted by Jo Raymond on