I've just finished setting up my loom (4 harness nilus leclerc) with a pattern I found on this website.  I can't seem to get the pedals to go down all the way & therefore the shed isn't wide enough.  My tension seems to be even & I've messed around with the tie up strings to see if that would make any difference (but it doesn't).  Here is the pattern I'm using with a 3/2 cotton: 

http://weavolution.com/draft/broken-twill-0

I can't figure out what is wrong or how to fix it.  Any help is much appreciated! Thank you.

Comments

ReedGuy

The draft in that wif file is for a jack loom tie up. The balanced tied up is the reverse.

OOOX

OOXO

OXOO


XOOO

X's are the shafts that go down.

Artistry

Since your treadles aren't going all the way down and not getting a good shed, I'd take a look at at your loom. I have a Nilus Leclerc too:) Here's leClerc's website if you want to look at drawings. Especially look at the drawing of the treadles, lamms, and shafts, you might have something going on in there. http://www.leclerclooms.com/draw_inst/Draw_inst.htm

ReedGuy

Often times a cord could be crossed or tied wrong. On some looms even the way the cords pass by the upper and lower lambs can restrict movement. On mine I have to be sure my cords all go in front of the lower lamms (say number four) if I'm tying to the upper lamm number four. Or if I start tying on the back side of number 4, have to tie on the back side of the rest of the lamm tie ups.

pammersw

This was a cross post and the problem was solved in the other thread.

Submitted by veganweaver on