Would you get a LeClerc Mira 36" or a  Hammet 45"?? Both 4 shaft and 6 treadle and both around same price! I am going to look at them tomorrow (Sunday) to buy one of them. I need help choosing before then!! Thanks!

Comments

ArtistInNature

...in a similar situation. The Hammet was in poorer condition, but took up much more floor space for its weaving width than did the Mira. I'm just delighted with my 4H CB Mira - my first floor loom and one that will last me for years.

Of course, the best answer is "it depends on what you want to weave": if you want to weave really wide stuff, the Hammet may be better for you.

Julie

La La

Hello: I have a 45" Hammet-4 shaft and 6 treadles. It is very sturdy, but does take up a good deal of space. There always seems to be some adjusting to do, but on the whole I like it a lot....

jlread (not verified)

would definately be the Mira...they are easy to work on and parts are still available from LeClerc

jessiesurber

Thanks for the replies. I am wanting a smaller footprint if possible. I am mainly wanting to weave wraps which are 30"- 32" in finished washed width.

With a 36" loom and using cotton what would my shrinkage amount be? Could I end up with a finished project at around 30"-32" with a 36" loom or is that not possible? Maybe the 45" loom would be safer?

sally orgren

Yes, you would end up narrower due to take up. I have been told historic patterns were based on fabric 24" wide. There is always a work around to a narrow width. One solution, double weave, you can weave 2x the width. My first loom was 4 shaft, 24" with a small foot print. I still weave on it. A loom this size has less loom waste, making it a good choice when using expensive yarns.

jessiesurber

I am not going to pick up the loom until this coming weekend. The lady couldn't make it on Sunday.

My mom had someone tell her that I should stay away from LeClerc looms. No explanation. I don't know what to think!

 

 

tommye scanlin

In my opinion, LeClerc looms are fine tools.  I've owned and used several, including tapestry looms.  One of the things I appreciate about the looms is that the parts are easy to come by from the company.

That said, I've only had limited experience with a Hammet.  So... these comments are just my opinion!  I'm sure you'll use either in good ways.

Tommye

SallyE (not verified)

You will know which one to buy when you get there and can see them both.   I'd go for which ever one seems the most sturdy, assuming the space each takes up is doable for you.

Karen6

I really like my old Hammett loom.  When I got it, it had been completely taken apart, but fortunately still had everything.  It took a while to figure out how to put it back together, but now I can fix anything on that loom.  It weaves great and makes a fine shed.  One harness vs. three is not a problem.  Even though it is a large loom, I got down to less than 24 inches loom waste on my last project.  Note - mine is fairly tall at the breast beam.  For best comfort when weaving, you may need to adjust the height of your bench.

Submitted by jessiesurber on