I just purchased my new Eeva loom from the wonderful Manning School. Unpacked it, put it together, loaded it with a beautiful gamp project and threw my first pick. Needed to advance the warp but went too far. My beater will not hit the fell line. I am trying to figure out this worm gear/ brake system and for the life of me I cannot figure out how to move the cloth back toward the back beam. I am beginning to think I have put something together wrong because I cannot correct my mistake of advancing my warp too much. Can anyone help?

Comments

Claudia Segal (not verified)

I suggest you give the Mannings a call if no one here can help you out.

I am considering buying the Toika Eeva.  How hard/easy was it to tie up the treadles?  Are you doing a straight twill or plain weave?  How many shafts do you have?  

I am sorry I cannot help.  I have a ratchet and pawl on my Glimakra Standard and it's easy to go back wards when you advance the warp too far.

If no one at the Mannings can help, call WEBS and talk to Barbara Elkins.  She is the TOika expert.

Claudia

MaryMartha

When I bought my Toika Norjaana (long since sold), the seller  suggested we photograph the front and back worm gear assemblies for reference. (below).  The way I remember it, to engage the worm gear, I needed to raise up the plate at the back so it caught the teeth of the back gear and then tighten the bolts.  From that point, I could wind the warp forward OR back using the gear handle at the front.  But try that gently.  There should be no force involved.

The Norjaana was not the loom for me, but I did love that worm gear.Congratulations, and hope this helps.

Mary

 

 

MaryMartha

Looking at my own pictures, I realize you may have to release the pawls at the front with your hand before you wind back.  As Claudia says, Mannings or WEBS can set you straight.

Eileen Crawford

I have my first warp on my new Eeva, and am amazed at the ease of use with the worm gear on the warp beam and the ratchet and pawl on the cloth beam.  When the pawls are released on the cloth beam, you are free to rewind with the worm gear the warp until your beater meets the fell.  Deb Chandler taught me to use a wooden bobbin as a measurement between the breast beam and the fell line to avoid over advancing the warp.  

Submitted by Barbaraz on