Hello. Recently arthritis in my knee makes treadling very painful. I have a 36" 4-Harness loom. It is made by Leclerc. The model name is Artisat. Has anyone solved this problem by modifying their loom? I am not sure how to approach this problem. I wrote to Leclerc to see if they have an "air assist" kit I could purchase to install. I would hope there is something to aid in lifting the harnesses that will ease the stress on my k.nee.. I have not received a reply. Any suggestions are welcome! Thank you Patty Glynn

Comments

Sara von Tresckow

Using a counterbalance or countermarche loom (like the LeClerc Fanny or Mira, Glimakra Julia, Oxaback Lilla, etc.) would go a long way. You are tipping the balance of the shafts, not lifting heavy wooden frames including the metal heddles.

Using a well constructed table loom with levers mounted on the front of the loom would be another option.

For a jack loom like the Artisat the only possibility is mounting the treadles with a back hinge rather than at the front and that brings only some lightening of the force needed to treadle the loom. The only models with air assist that are out there are the computer assisted dobby looms.

You are not alone. Many weavers purchase these rising shed looms when younger and do not forsee the issues that arise from the treadling force needed as one ages.

sequel (not verified)

Before you give up, are you sitting at the right height?  Your hips should be above your knees, your elbows above the breast beam.  When you are correctly seated the quadricep muscle does the heavy lifting of your leg and the shafts.  The difference of an inch may make your treadling more bearable

Vennui (not verified)

I agree . I don't have to lift my legs only shift my feet . I think it as a duck walk.

sandra.eberhar…

I agree with Sara about a counterbalance or countermarche loom being far easier to treadle.  I think that jack looms are the most common type of loom in the US; they can be made inexpensively, can be very compact, allow good patterning and are easy to tie up.  The downside is that you are lifting the full weight of the shaft with your muscles.  If it is a compact loom that is only 3-4 feet deep, it gets harder.  If it is 4' wide with steel heddles, still harder.  Here are some things that might help:

Although the weight of steel heddles is  thought to be needed to bring the harnesses down, I have heard of good results with changing to Texsolve heddles.  It removes a lot of weight from the shafts.

Have the loom altered to attach the treadles at the back.

Make the loom deeper by adding a back beam extension.  This will decrease the pressure that the warp makes on treadling.

It might be easier and cheaper to sell the Artisat and buy a different loom.  Four shaft counterbalance looms are fairly common and inexpensive, countermarche are more expensive; it depends on what you want to make.

pbgweaves

Thank you so much for your quick response and for the ideas. I am mulling over the options and will let you know what works. Patty Glynn

Submitted by pbgweaves on