I have a #10 reed that is just rusty. Seems to be in good shape otherwise but it's hard to clean the rust off between dents.

I talked to a pressure washer person & that seems to be the way but I'm concerned about ruining the binding.

Please, any suggestions?

Comments

Loominator

Help, just learning how to use this site. Hope I'm posting things properly.

sandra.eberhar…

I have heard people say they can take rust off with vinegar, but I am skeptical of this.  Naval Jelly works well.  The real problem is that after you get the rust off, you may have pits left.  I have seen posts where people have sand blasted the reed with walnut shell powder to fix that. If you intend to use the reed for heavy thread, like cotton rug warp, pits may not be a problem.  I would not use a derusted reed for fine threads.

steve104c (not verified)

There was the same subject a few subjects earlier. Best to replace with a new stainless reed. It is difficult and most of the time, unsuccessful when trying to clean a rusty reed. I have refurbished several looms and ended up replacing the rusty reeds and rusty heddles. Less headaches and a better loom for it.......Steve.

Gone

I've been using "Metal Rescue" for a few months now on projects. It's sold at Menards and I'm sure Home Depot too.  Looks and smells like water. Safe on everything except rust. Let it sit for several hours or over night. Heavy rust, use a second application.  A reed, depending on it's length can be a little long. You may need to devise some sort of container to lay it in. Like a piece of gutter. I just taped up a cardoard box to confine it  and put the reed in a large plastic bag (that didn't leak), poured it in and let is sit.  Came out beautiful. No special rinsing either. "Metal Rescue".

Submitted by Loominator on