Hello fellow weavers. I hope someone out there can help me with my latest project that I'm prepping for class. I'm working on a series of 3 ties - originally I wanted to weave a Christmas present in satin ground w/ supplementary warp stripes, but since I'm using class time, it's better to warp for 3 ties and do a little something different with each - and this is were your help comes in. I've figured out how to accomplish my initial design, but for the second tie I wanted to try weaving either damask or brocade. Based on my research, it seems like brocade is more of a supplementary warp and so would be in the same vein as the original project, thus befitting the warp with which I've already dressed the loom. Also, it seems like a rich brocade design could be accomplished with just the 8 shafts I'm limited to, whereas damask would require many more for a complex pattern. Is this right?

Though I understand the theory behind these weaves, my biggest issue is actually finding drafts that I can reference/use. I have too little experience creating my own drafts to go that route, so I could really use some resources. Anyone have any thoughts? Since I'm using strong, but extremely fine sewing thread w/ a bit of sheen when the light hits it, I think I could really create something stunning if I could figure out a design and how to make it happen. As this is a small piece, I'm not opposed to doing some pickup work either, though again, I don't have any experience.

Comments

Bonnie Inouye (not verified)

Brocade is a supplementary weft technique, woven in small areas and not edge-to-edge.

Damask is satin with a design of warp-emphasis satin contrasting with weft-emphasis satin. You have probably seen damask table linens.

Both have been used in many parts of the world for many centuries and you could find photographs in a book on weaving or textile history. Proper loom-controlled damask requires at least ten shafts (two blocks of 5-end satin) but sometimes people call a broken twill "false damask" and you could do this on 8 shafts.

You can weave many different designs and some different structures on any consistent threading, but not randomly chosen structures. And it would be harder if you don't want to make your own drafts. But there are many books and articles with more than one design on the same threading, so you could start with one of those. Maybe there is a library you can use.

Commercial men's ties are cut on the bias. There are sewing patterns you can use and I have seen articles in Handwoven about ties. Fine threads are best, and you want a structure with nice drape. Good luck. I think you are right that you could make something stunning.

Sara von Tresckow

Your choice will be very easy unless your loom is a countermarche or counterbalance and outfitted with long eye heddles, you will be able to do only brocading on your warp.

Damask requires, even for using a pickup stick, the long eye heddles and countershed to produce the proper shedding to work both faces of the satin on one side of the fabric.

Submitted by be.wierd on