I am weaving the potholders from Handwoven Issue 125, May/June 2005. I am using carpet warp and doubled worsted weight yarn, as called for, but cannot get anywhere near the ppi. My 8" square potholder is going to be 8 x 12, plus borders. The only thing I've deviated from is using a 10 dent reed instead of a 15, and I threaded 2,1,2,1etc. Could this make a difference?

Nancy

Comments

sally orgren

Your sett is equivalent with the 10 dent reed, so I don't see a problem there.

For your pattern weft, you mention "double worsted weight yarn as called for." I see the pattern used 100% cotton worsted weight yarn @ 805 yd/lb, 120 yd/2.5 oz ball. (Sugar & Cream). Is this *exactly* what you are using as pattern weft? (Where did you see the "double" worsted weight reference?)

If you have choosen another weft, you may want to make sure the yd/lb is the same as the recommended weft. "Yards per pound" is how weavers can affirm we are talking apples-to-apples about a specific yarn. A slight change here could make a world of difference.

Another element to consider, in Step 10, when it says to "Beat firmly to square the blocks" they aren't kidding. What kind of loom are you weaving this on?

If you are weaving this on a table loom, you will need to really "squeeze" the beater to pack the pattern weft in. I am not sure if this could be woven properly on a RH, as I am not sure how you could pack the weft picks in as required with a typical RH reed.

Finally, if your piece is *slightly* elongated while on the loom under tension, (8 x 8.25"), I wouldn't fret. You usually have more take-up warp-wise than weft-wise, once you take it off the loom (meaning the length may shrink more than the piece will shrink in the width).

I wouldn't hesitate to make adjustments as needed, beat (or squeeze!) firmly to square, and then cut off a sample to use as a guide for the next one.

As a last resort, remember when treadling Rosepath patterns, you can always eliminate some of the redundant pattern treadlings to reduce the motif if needed, especially if using a bigger pattern weft. In the center block motif of this pattern, at one point you treadle (3+4) 5 times. What happens if you only treadle it 4 times? The key if you make adjustments is to look at the pattern overall, and make sure it appears balanced/square.

Good luck, and post some photos if you get a chance. This looks like a great project because each potholder can be very different from the next. (And having an elongated pattern is not going to hurt the functionality of a potholder one bit! ;-) And hey — 8 X 12" might be the perfect size to make an eyeglass case by folding the fabric in half...

phiber phanatic

Sally, the reference to using the pattern yarn double is in step 8 on p. 32. I am using a 4 harness Ashford table loom. I am not using sugar & cream, I didn't think to compare yardage, but now that I do, what I am using is 115 yards for 50 grams, or about 1035 yds/pound. On the tabby hem, I was getting the 20 called for. So I will try both a skein of sugar & cream, and my cotton but with 1 strand instead of 2. 

I appreciate your help.

Nancy

 

sally orgren

If your tabby hems were on the money at 20 ppi, I am sure it was the difference in the pattern weft. Good luck, and don't forget to post some on loom or finished project photos!

 

phiber phanatic

Thanks to your enthusiasm, Sally, iI soldiered on. My first one had both a warping and weaving error, but the second one was perfect! I also noticed that the instructions said the pattern was square, not the potholder with hems! I am out to the store for sugar & cream to make other color combos. Pictures will follow. 

Nancy

 

phiber phanatic

The potholders were a wonderful learning experience, but just don't really fill the bill as potholders (unless the pot is not very hot). So I went on and used a Barbara Elkins pattern as inspiration and made a small runner. I will post it as soon as I figure out how. Again, thank you Sally, for the help and enthusiasm.

Nancy

sally orgren

Another idea to make those handwoven potholders more functional...JoAnn's sells some silver, heat deflecting fabric, I think in their "utility" fabric section. (also used for ironing board covers.)

So one side can be your wonderfully soft handwoven, stuffed slightly and stitched to the heat deflection fabric on the other side.

Our guild did a potholder exchange one year, and that is how I learned about this fabric.

Can't wait for photos of both!

phiber phanatic

Blooming leaves overshot. I haven't hemmed the potholders yet, so they're not up.

Submitted by phiber phanatic on