Can someone please post a clear photo of how the U-shaped piece fits over the teeth of a Weaver's Friend rug loom? (I am referring to the toothed wheel that allows the shafts to switch position, located under the loom.) Our part broke, and I may need someone not familiar with this loom to make the repair in my absence. A good photo would help me explain what needs to be done. Unfortunately, the part broke in two before I had a chance to capture an image for the volunteer. Your assistance is *greatly* appreciated!

Comments

Michael White

run by Leslie and Paul in MI are the keepers of parts for Newcomb looms. Paul is a blacksmith and has parts casted or machined for your Weavers Friend loom which was made by Newcomb. I have PM you her email address. Leslie should have a picture also.

Michael

sally orgren

Oops. I was referring to the model made in Springfield, Ohio. I just saw a slew of Newcombs in Iowa last week, but not sure if the mechanism is the same. Anyone know?

Michael White

I am not certain where the Newcomb loom was make. A good question for you to ask Leslie.

sally orgren

I am originally from Iowa, so that is an easy one!

And I have been researching Deen looms for some time (made in Harlan, Iowa). Barb Burnett lives in Plainfield, and has a climate-controlled barn filled with Iowa-made looms—it was really incredible. And she doesn't just collect, she weaves on them, so she knows their personalities!

oldhausfibers

Having just seen my 1st Dean Loom, In an undisclosed Upper Midwest State, and having personally seen many many auto shuttle Newcomb Loom from the early 1900s In another undisclosed Upper Midwestern state. 

The mechanisms are NOTHING alike.  The Newcomb has a large cammed wheel in the lower center of the frame. It is painted Dark Green, as all branded Newcomb looms are (on the cast iron pieced) 

The Deen seems to have a series of steel rods, that coordinate with a piece of spring steel in the beater bar that activates the shuttle "throw" 

Harland is a long way from Davenport (in Iowa terms, another country)  Davenport being a large heavy industry river town. With the Likes of McCormick Deering / Farmall / International Harvester.  With John Deere with main offices in Illinois and multiple heavy manufacturing plants in Iowa.  The Famous John Deere Tractor Plant in practically downtown Waterloo. 

Harland is a small farming community in the western part of the state, with the lowest population density of all of Iowa.

Again these are heavy CAST Iron parts.  Not a piece that a blacksmith could make. 

I see the Dean is many off the shelf steel pieces.  Plate steel, angle steel,  cast iron, wood.  The Newcomb is primarily wood, some cast iron, only the peddle bolts 1/4-24 type and the metal headles.  The machines only similarity is they are 4 headle machines.  Newcombs had either 4 or 6 pedals, as the Dean has a series of round cast iron cams which actuate the headles, there are NO PEDALS. 

sandra.eberhar…

This was an old post, so I don't know what the outcome was, but just because the original part was cast iron doesn't mean that a replacement can't be forged by a blacksmith, or any other metal working technique.  I had cast iron ratchets replaced with ratchets cut from sheet steel (3/4") by water cutting.  Cast iron parts were an economy of manufacture in the technology of the time.  My cut steel ratchets are lighter but stronger than the original cast iron, which were replaced because they were missing teeth.  When replacing parts on old looms, it works better to look at the part, the stresses on it, and find the best current technology to make it.  That might be a machine shop, or a 3-D printer.  Most farming communities have a versitile machine shop and welders.

Submitted by sally orgren on