I bought some mohair (Fleece Artist Goldihair and Goldilocks) to make a throw. So far I have wound the warp and made a small sample and ran into the expected problems with sticking threads. I haven't woven with mohair so would appreciate any suggestions that will make this go easier. I did see a post about using a mane detangler but have no idea where to find that.

Comments

JacRoyce

Hi

Are you using mohair for the warp? If so, you'll be miserable and probably quit the project just a few inches in. I try not to be so negative usually, but mohair warp will just beat you up. I learned this one the hard way.

Mohair weft, on the other hand, is cool! I like to use something thin, strong, and kinda slick for the warp (like tencel). This kind of warp will give you structure without weight—the last mohair shawl I made feels like a cloud. For warp, you're mainly looking for something strong and tightly plied, so that the mohair can slide over it when you beat in the weft.

If you decide to take the mohair warp off the loom (I know it's a drag to undo your work, but...), you can use all that mohair as weft. Even though you have many long pieces instead of one long strand, the joins will be invisible.

Good Luck!

 

Bonnie Inouye (not verified)

What kind of loom are you using? If you have the warp on 4 shafts (or more) you can raise one shaft at a time. This helps with sticky warps.

Mohair is not suitable for warp-faced weaves. You can use it for balanced weaves with a relatively open sett and beat if this is what you like. I prefer to use mohair for the weft, especially if it is a brushed (already fluffy) mohair yarn. For warp in a warm blanket or afghan, I use a smooth yarn that is 55% mohair and 45% wool, called "Texas", from Henry's Attic. This yarn is easy to use and I brush the finished piece after it comes off the loom.  Weavers who produce many afghans, blankets, etc often weave with smoother yarns and brush after weaving. This lets us make a more durable product (more yarns per inch) without the hassle of warping with a brushed yarn.

Bonnie

amyfrey (not verified)

The warp is mohair and the weft is mohair boucle, both blended with 24% silk and 20% nylon.  The directions were for plain weave with 8 epi and ppi which was how the one on display at the shop was made. I have a counterbalance loom so I'll have to see if I can get the one harness to one treadle tie-up working as suggested on the Jane Stafford site.  Thanks for the help.

loomroomcat (not verified)

the product that I have had good luck with is called Cowboy Magic.  You can find it at Tractor Supply Store (TSC), any saddlery or out of a catalog such as Jeffers Equine Supply.  It is in a tube like handcream.  Works wonders on mohair warp.  I just bought some acrylic to weave a throw for my elderly aunt.  It is very fuzzy.  The cowboy magic is working well on that as well.  Rub it on your hands and fingers and then comb your fingers thru the warp on the loom both in front and behind the beater, all the way to the front of the heddles.  YOu may have to repeat as you advance your weaving, but it works wonders.  Good luck.

Penn (not verified)

Which Cowboy Magic product works well on mohair?  They have a number.  CM Detangler & Shine?  CM Super Bodyshine?  Or another product?  TIA!

SDSue (not verified)

Hi, I have spoken with Alexandra Petrowski of Singing Falls Mohair in Oregon and she uses a "sizing" made from corn starch for her mohair warp. She weaves a lot of mohair. This is her "recipe" from memory:

1 gallon pot - fill about 3/4 full with cold water and then approx 4 tablespoons of corn starch to that - stir...then gently heat up until it's very hot and it should thicken just a wee bit when it's almost to a boil.  Add a tablespoon if it seems to thin...

anyway - then you just stir well and turn off the heat -

then when it's cooled enough to handle - you dip your warp yarns that you've already spun up and washed well and that are ready for warping the loom...then dry them outside - until you have some rather stiff spaghetti yarn -

you don't want the yarn gooey (but everything will eventually wash out, no worry) -- I learned over time just the way I need it to be - it's just slightly "stiff" after drying but the main thing is that it is rather smooth and the hairs of the mohair won't get caught so easy in the heddles of your loom...

I have tried this and it works. I have an 8 harness Macomber loom with wire heddles.

SDSue (not verified)

forgot to say that you should use 2 ply at least for this method.

 

loomroomcat (not verified)

the one I use comes in a tube and says concentrated detangler and shine.  It is about $12 for the tube.  You only use a small amount so it goes a long way.

Cathy

amyfrey (not verified)

Hi SDSue

That sounds scary - putting the whole warp in a pot of cornstarch solution.  I gently washed the sample that I made and the fringe tangled quite a bit.  The thought of getting the whole thing wet gives me palpitations!  Have you ever tried spraying the solution on the warp after the loom is dressed?

Amy

sequel (not verified)

I've always been afraid to try warp dressings.  Why doesn't the whole skein or warp just stick together in one big clump?  How do you keep the strands separate?

JacRoyce

Hulloooooo

I'm glad to read that it is possible to use mohair as warp. I'm not convinced I'll ever try it again, though. 

 

laurafry

My preference is to use the boucle as warp, brushed as weft.  However, that doesn't help you with your current warp!  It sounds as though it is already on the loom or was it just your sample?  Can you change and use the boucle as warp?

You can weave with the brushed mohair as warp.  Jane Stafford's information is the best I know although there may be others with good suggestions.  You just have to take your time and clear every shed.

As for your fringe, I'd probably twist the fringes to make them behave better during wet finishing.

cheers,

Laura

amyfrey (not verified)

I've got more than half of the warp wound on - it looks like I'll have enough left over for a scarf or shawl as well.  I'll try the "leftovers" with the boucle as warp to see how that works. I tied up the loom to raise one harness at a time - looks like it will work really well. 

I'm kicking myself for not taking a picture of the skeins of yarn before I made the warp.  The colour bands were very distinct but the overall effect on the beam is quite muted.  It will be interesting to see what the finished product is.  Now I'll have to figure out how to post some photos.

Amy

amyfrey (not verified)

I finished the throw - I'll try uploading a couple of photos soon.  I had another look for Cowboy Magic and bought some.  It works like - magic! The other hint about lifting one harness at a time worked well too. There is enough yarn left over to do a shawl or scarf as well.

 

loomroomcat (not verified)

I tried alot of products when I had the queen size mohair blanket on my loom and could not open the shed.  Corn starch, hair spray, hand lotion.  When I hit on the cowboy magic, it was like you said magic.  My shed opened and I was able to finish the blanket.  I keep a tube in my studio at all times.

Glad it worked for you.

CAthy

Penn (not verified)

I have a little stash of mohair I'll get to someday, and will file this away for reference.

Marie P

I found some beautiful hand dyed mohair yarn - enough for a nice size scarf (now all we need is the weather to go below 60 degrees here in Mass.) The info here is just what I needed as I wanted to do the warp and weft both in the brushed mohair. Sampling with a worsted wool warp just didn't cut it. 

Thanks! 

Marie 

mneligh

The problem isn't the fiber (mohair) but the preparation.  What folks above say about the problem with brushed mohair is true to varying degrees with any fuzzy yarn.  Dressings like those mentioned above (I like Mane'n Tail) and not raising adjacent warps together work wonders.

Boucle (as Laura mentions) is a special case because it is typically a cabled yarn, and each ply has a tighter twist than brushed mohair so it isn't fuzzy and doesn't catch as much.  Boucle may be made out of various fibers as long as the loopy fibers are relatively stiff like mohair.

Navajo warp is frequently mohair or mohair blend.  It is smooth and just about the best warp around.

MMs-and-OOs-Ha…

I have done a lot of loop mohair, warp, and brushed wool, weft, weaving, using commercial yarns. Most have a synthetic binder. Part of the trick is to pick a weave structure that is open like a 2/2 twill and to sett the cloth a bit looser. I have never used dressings and have done doublewidth throws, and you don't want that sticking on the lower layer, you can't see it. 

Submitted by Anonymous (not verified) on