As I was threading my heddles I noticed that I should have two more treads than what I had. I'm still in the process of threading the heddles, I've cut the warp threads I need to fill the color requirements, but I don't know how to incorporate them into the rest of the warp (i.e. weight them so they will be with the other warp threads). I know that I've heard of weighting the floating selvage, but not new threads in the middle of a project. Thanks for any help!

 

Comments

sequel (not verified)

Measure out the warp threads you will need, using the guide string on your warping board, but add another yard or so to the total length of each .  You will thread these warps through the heddles as usual, the additional length will not be wound on to the warp beam, but will hang over the back, neatly chained.  In the uppermost chain loop you can add a hook, to which you will add enough weight to make the tension match the rest of the warp.  I usually do this after the warp is threaded and tensioned, having left the appropriate heddles and reed dents open for them.  The extra length you added is to maintain the tension even after the back stick has come up over the back beam towards the heddles.

karentiede

Depending on what you're weaving, think of fishing weights, dead batteries, and/or rolls of coins as weights.  Fishing weights get expensive in larger numbers; a $10 roll of quarters weighs 8 oz.  (One might think a $10 roll of quarters should be worth more than an 8 oz fishing weight, of course, but I'm using the quarters to remind me I'm supposed to be selling these rugs.)

(On my rug loom, 3 oz of fishing weights wasn't enough to tension a repaired warp thread...)

mrdubyah (not verified)

The plastic canisters in which 35mm film used to be sold are perfect for warp weighting with fine warps.  Put as many coins or washers in the can as necessary to get the right weight and pop the cover on over the warp thread to hold the can in place.  Shower curtain hangers are also a good choice for thicker warps.  Open the hook and thread on as many fishing weights and washers as needed, then put the clip on a loop of the warp thread. 

Submitted by conniela on