Obviously, the distance from jack axle to shaft jack connection on (right and left sides), needs to be constant to enable the shaft to rise and fall parallel to the the floor. But is the distance from axle to the lam connection (top) ever increased or decreased for leverage advantange?

 

Comments

Joanne Hall

are tied at the height which will allow them space to move.  Shortening this cord is done to raise the lower lamms if, for instance, the lower lamms are touching the treadles when a shed is opened.  Leverage is not a part of this adjustment.  It is only for keeping the lamms from touching either the treadles or the upper lamms. 

When first doing the tie up, the shafts are set at neutral.  If all the lamms and treadles are set in logical positions, then the shed will open properly, some shafts rising the same distance that the other shafts are sinking.  If any lamms or treadles are touching other parts, the shed will not open fully.  But the height of the lamms and treadles, when in their logical positions, does not have anything to do with how hard it is to treadle or the balance of the parts.

Joanne

Maurice

I guess I didn't state my question clearly. On a vertical countermarch loom, the jack for any one shaft is divided into roughly three parts, either by connection hooks or holes. Of the lower two connections, one is at the bottom of the jack, the other equidistant from the jack axle by the distance from the jack axle to the bottom connection. The cords from them go over pulleys in the castle and  then down to the upper shaft bar on either side. The third connection on the jack is at the top and its cord goes over a pulley on one side of the castle, opposite the side with the fulcrum for the lamms,  and thence to the long lamm. This connection usually appears to be at a distance from the jack axle equivalent to the distance between the two shaft connections on that same jack. Moving this third connection higher or lower would change the amount of force on the jack from the weight of the lamm. It is, after all, a lever. My question is, has anyone used this varying leverage to facilitate the balance on a loom

Thanks,

Maurice

Joanne Hall

I have two vertical jack countermarches from different makers.  The measurements are very similar on both.  The holes for the cords going to the shafts are 6.5 inches, 16.5cm from the axis on one and 5.75 inches, 15cm on the other inches on the other.  The lower lamm tie is 11 3/4 in, 29.5cm  from the axis on the first and 11.5 in, 29cm  on the second.  Maybe these measurements will be helpful to you. 

Joanne

Maurice

Very helpful, Joanne. Yours is the third corroboration of the validity of this idea of varying the long lamm jack atachment point. Heard yesterday from Bill Koepp who has used this technique to alter balance---by trial and error---and today we saw a Harrisville Rug loom (our second viewing ever) and the long lamm jack point attachment is a different from the axis than than from the axis to the shaft attachment points

Maurice/Deborah

Submitted by Maurice on