I've just beamed a new warp on my loom (front-to-back) and I noticed that as I tied the ends onto the front apron rod, the ends aren't even. They are very short on the right side of the loom and gradually increase in length across the warp to the left side. I thought I maintained good tension as I wound onto the back beam; or could it be differential tension as I measured the warp? Any thoughts? Thanks so much, Monica

Comments

mneligh

There are several things that might cause this, including different tie lengths on the back end.   If the distance between the ties is uniform (one beam or the other isn't at a slant, like not well seated, etc), and if the tension is uniform, the length of the free ends of the ties is irrelevant and of no concern. 

Make sure the distance from the  warp beam over the back beam over the front beam to the cloth beam is identical on both ends.  Then verify the tension by touch.  Make sure the layers of warp are well separated.  Weave a few rows and make sure your fell line is straight.  If it is, you have nothing to worry about from this.

Bonnie Inouye (not verified)

How long is your warp? Did you use packing material to keep everything even? Weavers use flat sticks or slats (from blinds, for example) or heavy paper or wall paper or cardboard in between layers as the warp is wound onto the beam.

I would check the circumference of your warp package at the back of the loom. Take a measuring tape and measure the distance around at the right-hand side and at the left-hand side and in the middle. They should be exactly the same. If they are, then your different lengths might have come from something you did as you tied on before winding. If they are not the same, then one side was wound more tightly than the other and this will create major problems as you weave. The longer the warp, the greater the problems are likely to become.

Bonnie

Monica Bellas (not verified)

The warp is four yards. I've got a sectional beam that I'm using as a "regular" beam; in other words, I'm not sectional warping. I'm using slats to cover the knots on the back beam as I wind on the warp. In the morning, I'll measure the circumference of the warp package tomorrow. Meanwhile, the fell line is straight, so I'm hoping I don't have any problems. Thanks!

Joanne Hall

all in one bout?  Wide warps should be divided and wound into equally sized bouts.   If you wind too much in one bout, one side is bound to be longer than the other.  Holding or pinching the warp tightly as you wind can also cause this.

Joanne

Monica Bellas (not verified)

Joanne -- Yes, I wound it all in one bout with almost 600 ends. That's probably the source of the problem. What's the most ends you would recommend in one bout?Monica

Joanne Hall

can be anywhere from 40 to 300 ends, depending on the sett, the size of the thread and what you are weaving. Think of the inches of width rather than the number of ends.   I never make them more than 10 inches of the warp width.  For rugs, linen warps and warp faced weaves, 4 to 8 inches is a more common bout size.

Joanne

sally orgren

If you used a warping board, the warp you wound at the base of the board may be longer than the last strands wound, especially if you wind onto the board tightly. As you build up the bout, the pegs may bend inward, reducing the total distance of those last warps. If you wind smaller bouts, there is less of a chance for that to happen. (Yes, we've all been there, done that! ;-)

Submitted by Anonymous (not verified) on