I have a friend who hammered nails into several wooden yard sticks and taped them to her plain beam to make a sectional beam. I was thinking of doing this but wondered if I could purchase those u shaped brads (sectional rakes??) that I could 'hammer' into some wood strips to attach to my plain beam. Any ideas out there?

Comments

Joanne Hall

Before you make the sectional beam, ask yourself why you want to do sectional warping.  It is primarily done when weaving long warps, like more than 20 yards.  It usually goes with selling one's work and making 50 ro 100 yd warps.  It is also used by those who weave with very fine threads.  But if you are planning to do this because you don't have good results from winding and beaming shorter warps, then perhaps the sectional beam will not really solve your problem.  For warps less than 10 or 15 yards, it can be more costly and time consuming to do sectional warping.  A 3 yard warping reel might be a better investment.

Joanne

kerstinfroberg

And, if you decide to make one, remember that it is VERY IMPORTANT that the rakes line up! Even if they are just slightly off, the warping will not be half as easy or efficient, as you will have to watch every turn very closely.

steve104c (not verified)

I made my own sectional beam. LOOK! I got the large staple nails from GlimakraUSA($0.65 ea.) and hardwood oak from a friend. Saved about $ 300.00 doing it myself. It is a 1" sectional- for 45" beam.........Steve.

sequel (not verified)

All the Hammett floor looms I've ever seen had sectional beams with 2 to 3 inch pegs 2 inches apart.  As they age, they get "toothless" either because the pegs break off or they fall out.  (They are NOT glued in, unless someone has done it themselves.) Once they start shedding pegs, most people pull out the rest of the pegs and convert to an apron in the back.

If you have the big open back beam, with the cast iron "wheels" it should have holes drilled in the long wooden parts for these pegs. 

The big 45" looms had a tendency to torque due to having the brake on one side.  I tied the wooden cross pieces diagonally with wire and turnbuckles to bring the beam back into square.

 

Submitted by Anonymous (not verified) on