Please correct me if I'm wrong. I assume that as long as warp tension is equal across the entire warp, then it doesn't matter if you happen to tie-on or lash to your apron rods a little crooked, or if the rods get a little bowed in the tie-on/lash on process. I'm assuming this because as long as after the tie-on process your tension is even and tight that the warp will be pulled through the loom at an equal rate.
I ask this as I see on this board discussions of tying on vs. lashing. While it appears that lashing may be easier to adjust the warp, the discussions make no mention of whether lashing doesn't bend or bow apron rods less than directly tying on.
Comments