I found a baby blanket pattern I want to make but it calls for a 40" loom.  I have a 36" inch loom which really only take 35" in the reed.  Its the Bamboo baby blanket available as a free download at Weaving Today.   It calls for 3 per dent in a 10 dent reed.  In the past I've just guessed a bit on how much of the threading I omit but the current pattern is a bit more complicated.  I can't be the first person who's had to do this.  Is there a simple method for figuring this out?

Deb

Comments

tien (not verified)

If it's sett at 30 epi (3/dent in a 10 dent reed), one inch has 30 ends.  Your loom, with a 35" weaving width, can only accommodate 1050 ends (30 ends per inch times 35 inches = 1050 ends).

Since the pattern has 1200 ends, you need to omit 150 ends to fit it on your loom.  If you want to keep the pattern centered, then take out 75 ends on either side (so start with thread #76 and end with thread #1125).

Depending on how the pattern runs, this may or may not look attractive, so look at where the pattern repeats are and pick a spot that fits into the "rhythm".  I would personally skip the first section of the threading and start on the 6th repeat of the 7x section - that would be thread #83 - but I haven't done up the drawdown so I don't know for sure what that looks like.  I would work out the drawdown in weaving software if you want to be sure what that does to your pattern repeat.  I'd also put on an extra half-yard of warp so you can sample before weaving the whole thing.

I hope that helps!

Tien

DebD (not verified)

I don't have software but I was planning on sampling. 

You've helped me a lot.  I wasn't thinking about omitting individual threads and making it way more complicated in my head.  This helps a lot.  If I take out one of the threadings under the 5x and make it 4x that is 112 threads less.  Then another from both sides of under the 7x that puts me up to 140 threads.  Getting there.

Another question (maybe I should make this another forum topic).  But I noticed in the pattern article it says in one place that Bamboo 7 is the same as 5/2 perle cotton and in another place it says its the same as 3/2!?  I looked around a bit and I think its similar to 5/2 but I want to be doubly sure. 

tien (not verified)

Bambu 7 is 2100 yards per pound, the same weight as 5/2 cotton.  So you're right - must have been a typo in the article.  Good catch!

lkautio (not verified)

A slightly finer bamboo yarn that would allow you to use a tighter sett would allow you to fit all the original pattern threads into 35".  It would take a sett of 35 epi rather than 30 to fit in the 1200 threads in 35".

The yards per pound of the bamboo is the same as 5/2 cotton, but the article is correct in comparing the way the Bambu 12 and 7 are working in this project to 20/2 and 3/2 cotton which would take similar sett to that used in the project. 

Laurie Autio

Submitted by Anonymous (not verified) on