I am new to this forum. so i hope that i am politically correct :-)

my question is where to put my single peg when warping from behind. Each string needs to be 2.5 yd.  where do i start to measure the 2.5yd from what part of the loom.

i designed my own loom. have the parts now and it just needs put together. My first go at weaving is going to be the one peg method, but i am stuck on this...haven't been able to find anything on where to start the measurement.


thanx ahead of time...i appreciate a place to go so i can ask questions ;-)

Comments

Saille (not verified)

i forgot to mention that it's a table top rigid heddle loom

Claudia Segal (not verified)

I assume you are talking about direct warping the loom. When you calculate the warp, be sure to include loom waste, shrinkage and take up. I usually warp the rigid heddle loom from front to back by placing the peg in front of the loom. I begin by tying on to the back apron bar and measuring from the heddle to the peg. As you go back and forth from over and under the back apron bar you bring the yarn through the heddle slots. I hope this helps. You can find full instructions and diagrams in Liz Gipson's book, Weaving Made Easy or Jane Patrick's Idea Book. Both books are good rigid heddle weaving resources. Claudia

Saille (not verified)

thanx for the information.  But what i am confused about is how to figure how far away the peg should be. for 2.5 yards, should i put the peg 2.5 yards from the front edge of the loom, or the back apron, or some other place to measure from?

thanx again

illoominated (not verified)

Once I know how much total yardage I'll need (including loom waste, etc.), I measure from the front apron to the peg.

Karren K. Brito

Measure the warp length from the peg to where the yarn, warp, attaches to the loom. 

You will not be able to weave all of the warp length, the part you can't weave is called loom waste.

Submitted by Anonymous (not verified) on