Hi, i am very new to weaving and have just purchased a louet david 70, can anyone help me and tell me what would be the best yarn i could use, i will be allowing adults with learning difficulties to do the weaving after i have initially set up the loom.

in addition, does anyone know what an average sized T towel would use in regards to the quantity of yarn?

Comments

celtinbirks

Hi!

You might want to have a first project that uses thicker yarn:  like a scarf or a table runner.  Thicker yarn means less "ends per inch"  than thinner yarn that would be used to make a towel.  The less ends per inch, the easier.  Having a total of 150 threads would be better than 500 for a beginning project.  I have made lovely simple scarves with worsted weight wool.  Weaving can be very theraputic.  It is wonderful that you will be blessing these people.

Sara von Tresckow

Actually, using threads that are appropriate for the weight of a towel is easier once the loom is warped. Thick threads do not bend and behave as well as thinner.

8/2 or 10/2 cotton as warp and a weft of 8/2, 10/2, cottolin, 12/1 linen - or similar will make a nice, easy to weave project. The fact that you will be using 20-30 warp ends per inch will minimize shuttles falling through the web and give a nicer appearance to the finished project.

You calculate material usage by #ends per inch times inches wide to get the yards needed per yard of warp. Weft will be about 80% of that. Then calculate the area of your towels and add a bit for unexpected situations.

mrdubyah (not verified)

Example: using 8/2 cotton at 20 threads per inch you'll need 400 threads for a 20" wide warp (with pull-in and shrinkage this should give you a finished width of around 18").  You can theoretically get three 24" long towels out of every two yards of warp.  However, you need to account for loom waste and will want to allow for some space between the towels when weaving.  Throw on an extra yard for that.  Therefore, to make six 24" towels you'll need at least 5 yards of warp.  Total yarn needed for this warp would then be 400 threads x 5 yards or 2,000 yards.  Since 8/2 cotton yarn is, by definition, 3,360 yards per pound, you'll need .6 lbs or roughly 2/3 of a pound for your warp.  8/2 cotton typically comes on 1/2 lb. cones so two of those, or a single 1 lb. cone should be plenty.  Figure on using a similar amount for the weft.  In short, if I was you, I'd pick up a pound of white 8/2 cotton for your warp then get two 1/2 pound cones of the same size yarn in contrasting colors for the weft. That should give you plenty of yarn for this project with some left over for the next time!  Good luck!

gailc

For a 20 epi warp that is 20" wide in the reed, you need 20 threads per inch x 20 inches = 400 ends, not 200.

mrdubyah (not verified)

Ooops!  You are, of course correct, which means 2/3 of a pound rather than 1/3 will be needed for six towels.  I have corrected the text above and apologize for any confusion I may have caused.  You'd think by this age I'd have learned to multiply 2x2! Thanks for catching that.

Submitted by Anonymous (not verified) on