I have a second beam on my Schacht table loom and I'm having a hard time figuring out how to wind a second warp on the loom.

It would seem you wind the main warp first and then the supplemental warp, but it also seems to me that the main warp now gets wound onto the second gear beam, not the original.

There doesn't seem to be any kind of printed instruction sheet out there anywhere.  Can anyone help?

Thanks, Lydia in Texas    [email protected]

Comments

laurafry

How are you dressing your loom?  When using two beams I prefer back to front, winding the main warp onto the main beam, then winding the supplemental warp onto the second beam.

Both warps will have their own set of lease sticks from.  I then thread the appropriate ends from each set of lease as they are to be threaded in the heddles.

Cheers,

Laura

kendrick43 (not verified)

My plan was to warp the main warp first, front to back (it's the only way I know), and then add on the supp. warp. 

In the picture on the Schacht website it would appear that the main warp goes on the second beam and the supp. warp goes on the original beam.  I have an email in to Jane to see if she can help. 

Befuddled,

Lydia

laurafry

I'm sure Jane will be able to advise you.  Have fun!

Laura

kendrick43 (not verified)

Jane emailed and said the ground warp goes on the beam closest to the heddles, just like in the photo.  Seems strange to me, but I'm going to try it out as soon as I find a project in Handwoven with supp. warp that appeals to me.

ReedGuy

Depending on how the supplemental beam is set up here, and I'm thinking the supplemental is above the main warp beam like a Glamakra Standard, it would seem better to put on the supplemental warp first as your working against gravity with the warp coming over the roller and under the beam. Put that on first, with lease sticks and put it (lease sticks and warp) up out of the way. Then do the main warp, where your working with gravity. Anyway, that is the way I'd do it. That way the warps have no chance to collide until threading heddles and reed where they need to merge. Maybe it doesn't matter, but it seems that it would.

Andrew Kieran (not verified)

I would tend to agree with Laura, warping on to the beam first. Use a raddle to spread the warp, there should be plenty help available with videos on you tube.

Also, I'm not sure why, but I'd always put the supplemental warp on top. There must be a reaon for this, perhaps because supplemental warps are often used in pile looms?

Also, I've often found it's difficult to get two warps lined up perfectly from the beams to the shafts, so I found it helpful after threading to put in a cross at the back of the loom to keep the warp in order.

ReedGuy

I agree with what you said, it's actually what I described as I always use raddle and lease sticks anyway. But I see a pitfall if not first winding the supplemental warp above and having it out of the way with lease stick in tact. You plan the spread of the warp on the supplemental as you would with the main warp. It has to be so wide, but with two sets of lease sticks they can be spread independently. What matters most is how the two warps are thread as a merged warp according to the draft. I would not cut the bouts until ready to thread the headles. With just a couple of yards, enough to reach the tie-rod by the breast beam once threaded, you could easily toss the ends up over the cross bar in the castle, such as the one on a Standard and down the back and get on with the main warp. Now obviously both warps need to be spread properly. That's my method and am sticking to it. :)

Pile warp and warp cord padding are my uses for a supplemental. Neither of which are under strong tension, they need to be more slack.

Submitted by Anonymous (not verified) on