if I am using 20/2 cotton and have a 10 dpi reed, how many threads do I put in each reed?   thank you   joanlvh

Comments

laurafry

Depends on what you want your cloth to turn out like.  I have set 20/2 cotton anywhere from 30 to 40 depending on weave structure and what weft I'm using.  If you look at my projects, the red tea towels are 20/2 merc. cotton at 40 epi with a singles 12 for weft in the Woven Illusion, a 16/2 unmerc. cotton in waffle weave.  The waffle weave towels were a little stiff for my preference, so I'm going to re-tool that tie up and try it again.

At 40 epi I've got 4 ends in a 10 dent reed.  For 30 it would be 3 ends.  If you want something in between you'll have to juggle the denting a bit and do what's called a compound denting.  If you put 4 ends in one dent and 3 in the next you'll wind up with 35.

Cheers,

Laura

missbeckyohh43 (not verified)

Thanks for this chart.  I needed this.

Michael, or anyone else, tell me how I decide what size thread will go with how many dents per inch? Is this a matter of WPIs?

laurafry

It's a combination of how many wraps per inch divided by 1/2 for plain weave, a slightly higher number for twill, and the degree of drape you want for your textile.

For 8/2 cotton, for example, plain weave might be 18 to 20, while a 2:2 twill might be 24.  If you wanted a very open fabric, you might go as low as 16 for plain weave, as high as 27 for twill.  Satins would go higher yet, due to the fewer numbers of interlacements in the weave structure.

One good way to learn about set is to study actual textiles - find out how they were made and analyze them for how closely they meet your requirements.

Guilds often have collections of samples and there are still a few books around with actual samples in them to study.  Malin Selander did a series of books in the 70's/80's I think, Dini Moes did a book in the 1990's An Uncommon Thread, I think it was called, and Magic in the Water are some off the top of my head.

Older 'newsletters' published by people like Elmer Wallce Hickman in the US and Ethel Henderson and Mary Sandin (Loom Music) in Canada also had swatches.

Joining a study group helps, too, as you generally get samples to exchange with other members of study groups where all weaving info is provided so you know exactly how they were woven.

cheers,

Laura 

spring k (not verified)

i am just discovering that 40 epi in an 8 dent reed is not the same as 40 epi in, say a 10 dent reed. i did 5 threads of 20/2 cotton in an 8 dent reed and it is far too loose for what i was going for. i am not sure yet if i will go for 40epi in a 10 or perhps 48epi in a 12.

any charts that show this?

laurafry

What weave structure are you using?  At 40 epi for 20/2 cotton the fabric is generally quite dense unless you are weaving something like satin.  In that case you may have to go even higher than 48 due to the infrequency of the interlacements.

cheers,

Laura

Alison (not verified)

Another factor may be your beat.  The more threads in a dent, the more friction which may cause you to beat less firmly.  Do you have the same number of weft per inch?  Are you using the same weft yarn in both cases?

Submitted by Anonymous (not verified) on