This has probably already been done and is not exactly "equipment" but I am happy to report I have solved my issue of releasing the double pawls on the 63 inch wide Standard.  This size loom has a ratchet and pawl on each side of the warp beam and on either side of the cloth beam.

It is not physically possible to lean over each side of the loom and release the pawls at the same time (a 6 foot span between side frames).    I created a method using an eye hook under each side of the top beater castle.  I had two pulleys on either side of the loom but only one release handle.  I removed the handle and tied the end of the cord from the handle directly to the cloth beam pawl on either side.  I then took an additional piece of cord, looped it around the cord closer to the front cloth beam pawl, this cord then travels through an eye hook and across the front of the loom to a second eye hook on the other side, then again attaches to the pulley cord closer to the cloth pawl.  

Adjust the slack so that a gentle tug releases only the back two pawls on the warp beam, a firmer tug release all four pawls at the same time!  Very simple.

See attached pics.

 

bloominloom-dawnmccarthy.blogspot.com

 

Comments

TheLoominary (not verified)

Well planned and executed, and it looks very neat. I like the fact that the same action will release either the two, or all four pawls. Nice! Frank.

 

 

 

Joanne Hall

Hi Dawn,

Unless you are weaving the full width or a very tight tension, like for a rug, it is not necessary to keep the wheels attached on the left side.  You can weave most anything without them on the loom.  That simplifies advancing the warp.

Joanne

I just got back from teaching tapestry weaving at Madrona in Tacoma.  It was a very nice conference.

Submitted by Dawn McCarthy on