If I have an 8 shaft floor loom and an 8 shaft table loom can all patterns for 8 shaft looms be used on either?  thank u  joanlvh

Comments

naturalfibres (not verified)

Yes, you can use the same patterns on each loom; however on your table loom you will have to lift each shaft when treadling, instead of being able to follow the tie up for the patterns like you can do on the floor loom.

lkautio (not verified)

On a table loom you can have any combination of shafts you like.  The number of possible combinations far exceeds the number of treadles on a floor loom (and the patience of most weavers to get under the loom and keep re-tieing).  It's one of the major reasons for having a multishaft table loom - as a cheap dobby loom where all possible combinations can be used within the same project as desired.  You can add treadles to some floor looms (I had 18 on my 10-shaft Macomber) and use skeleton tie-ups, but it will never match the capacity of a table loom.  So, all 8 shaft patterns can be used on a table loom, though slowly, but only those which do not exceed your treadle capacity or re-tieing patience can be woven (far more quickly) on a floor loom.

Most of the published patterns you will find will not exceed the treadle limit (to make them more universally useable, easier to weave, and take up less magazine space).  There is a reason magazines tend to stick to simple little repeating motifs, even though the looms are capable of much more intricate designs.  If you look at patterns on handweaving.net, many of which came from industrial design books, you will run into a number that take more combinations than you will find treadles on most floor looms. 

Other limitations:

Inelastic fibers, like linen, are better woven on a deeper floor loom, unless you have a warp extender for the table loom (fairly easy to make but not commonly seen).  These fibers also tend to do better with countermarche or counterbalance mechanisms, which are less common on table looms. 

Width - many table looms are very narrow. 

Ability to beat - you won't be able to make rugs on a table loom even if it is wide enough.  A heavy floor loom is required to square some textiles at higher setts.   

Laurie Autio

Submitted by Anonymous (not verified) on