I have no "plain" warp beam for my new loom and was wondering if I can use the sectional warp beam to warp normally when I don't want to warp sectionally?  If so, how is it done?

Thanks, you folks are great!

CC

Comments

kerstinfroberg

Yes, you can.

The only thing that can happen is that the warp "hangs up" on the dividers.

debmcclintock

Absolutely, several choices, just go slow to make sure threads fall in the proper sectional area on the warp beam.

1.  if your sectional beam is divided into two inch or three inch sections you can beam separate warp chains onto the beam, just wind your warp in smaller sections

OR 

2.  you can make yourself mad by winding all the chains and winding them on all at once.  go slow, I wind my chains around my front beam to give them tension and then beam the warp slowly.  I make sure the proper chains are winding into the proper section.  Walk around to the front and tug on my wrapped chains (wrapped once or twice around the front beam) all the way across to ensure even tension.

I am sure you will get other suggestions to consider also.

TinaHilton (not verified)

I read about an interesting way to do this recently.  Unfortunately I don't remember the where or who to give credit to them.  They took pvc pipe with a slot running the length and slipped it over the pegs (one pvc pipe per row of pegs, obviously).

csheridan

I am new to the sectional beam issue. I see that you can use a regular warp chain (warp "normally" as another reader calls it), onto a sectional beam, making sure the threads fall into the correct 2" section. My confusion is in the cross? One would still use the lease sticks and make a cross and then draw the threads onto the sectional beam...correct?? Silly question, I'm sure...but at the moment, I am overwhelmed with several new learning curves going on!! Thank you!

debmcclintock

I guess my answer is "if you warp back to front"...as in you wind onto the warp beam before you thread heddles and reed.  Acknowleging that you are still new to a sectional warp beam here ya go:

1.  wind your warp sections to match your sectional warp beam  ie, two inches wide to match 2 inch section, secure your cross in your favorite method, there are many

2.  chain your warp up to your cross

3.  place your chain onto your lease sticks with your cross

4.  attached your warp chain to your sectional warp beam in your favorite way (there are many).  At this point some folks also spread their warp in a raddle to ensure their warp has consistent width

5.  pull your warp chain to the front breast beam and weigh it, I wrap it several times around the warp beam, others use water jugs, there are lots of choices to apply consistent tension to your warp as you wind it on

6.  wind on that particular section (leaving the lease sticks in place), loop it or use masking tape to hold it in place while you wind the other sections on

7.  Of course you resecure your cross and remove it from the lease stick so that once you are ready to thread your cross is maintained (this is the point where some folks point out they put a cross at both ends, a gross cross and a threading cross).  I just use one cross and tie and retie it.

8.  Repeat steps 4 - 7.  There is no reason why you can't wind all your chains and place them on the lease sticks.  You just don't attach them to the sectional warp beam until it is that chains turn to go on the beam.

Hope this moves you on to the next set of questions!  I don't advise trying to wind on all sections at once as you will fight the sectional loops on the warp beam BUT it can be done, just slowly and patiently!

 

sequel (not verified)

Are you sure your warp beam is not convertible? Tell us what kind of loom and a photo of your sectional beam can help.  Some looms are more convertible than you might think!

Submitted by celtinbirks on