I need some advice on what kind of studio lighting to buy.  My husband and I are restoring our 19th century barn. We're converting an existing room into a weaving studio.  The room is 12' x 24' with 7' 6" high ceilings and two good size windows on one of the 12' sides.  After tearing down old plaster board on the ceiling, we discovered beautiful original beams.  So I want to leave the wood ceiling and beams exposed, and drywall the walls leaving them a light color. Now I have to decide what kind of lighting to use.  I was thinking of using 4 sets of track lighting evenly spaced on the ceiling placed up between the beams. Each track would have 4 lights with halogen bulbs.  I never used track lighting so I'm not sure if it will provide enough light, or should I use 4' florescent units? Any advice would be greatly appreciated.

Doreen

Comments

lkautio (not verified)

I like track lighting with movable (along the track, and as spotlights - rotationally) individual fluorescents.   They are not quite as bright as halogen, but I believe cooler and safer. Enjoy your new space!

Laurie Autio

1gardenia (not verified)

Hi,

I have a studio that is 15 x 22 feet.  I also have beams on the ceiling and I have six windows. My husband has been installing fluroescent bulbs on the celing in the middle of the room.  I also have sconces with halogen bulbs.  I like the halogen lights because they are brighter but they light only a spot.  That is why my husband had to put another kind of lighting (fluorescent).  I hope you enjoy your new studio. 

Chantal

steve104c (not verified)

Just remember, halogen lights are very very hot and you will be installing them close to very old and very dry wooden beams. I am a professional firefighter, for 30 years now. So just a little advise. Think safty first. I have a floor ott light I use at my loom. Fluroescent fixtures aren't very attractive but do give off a lot of light and are cooler than halogen. Be safe.................Steve.

Michael White

Like Steve says halogen lights are very hot. Keeping with the style of the barn I would use nice drop lights and floor lamps with the new type light bulbs. The daylight bulbs give off a very bright light, low heat and lower cost. You can find light fixtures at the Habitat store, or a good thrift shop. Go to a lighting center and check out what is out there. FYI I moved from your part of NY to the warmer South. Stay warm in your -25f temps.

Michael

kellytwo (not verified)

This section of the barn has an upstairs, so the ceiling of this room is also the floor upstairs. Because of this I can't have a fixture recessed in the ceiling. I was very concerned about the safety of the halogen bulbs because I knew they get very hot, so I appreciate your input.  Also the ceiling isn't really high enough for drop lights, so I'll either look for track lighting that the new energy efficient bulbs can be put in, or use florescent fixtures even though they won't look the best.  Home Depot has a 2 bulb, 4' fixture that is only 8" wide. I suppose that wouldn't be too bad, even with 3-4 fixtures.  Although I would like this room to look very historic, I think the most important thing is to have good light for weaving.

Being in a warmer climate sounds really good right now. Tonight is suppose to be the coldest temperature of the season.

Doreen

weaver-dyer (not verified)

Your room is larger than my studio, but the ceiling height is about the same.  I have four 4-tube, 4-foot fluorescent fixtures with full spectrum tubes attached to the ceiling--not recessed.  With the all-over lighting most people do not notice the lighting fixtures as they are more intrigued by the looms, yarn, etc.

Although the fixtures provide lots of general lighting, there are times that I need more focused lighting.  When threading a black warp, I move my Ott floor lamp close to the loom.   

 

cirving (not verified)

Weaver - Dyer, I am in the middle of creating a weaving studio.  It is an upstairs of a garage, newly built.  We have not put in drywall or lighting yet.  So, I have a lot of flexibility.  I have been doing a lot of online searches so I get it right.  I have been leaning towards what you have, flourescent tubes.  Do you think you could post a picture of your lighting?

SallyE (not verified)

Halogen is too dangerous.   I refuse to have it anywhere in my house.  Even if they don't cause a fire, they are dangerous to be around because they get so hot.

Florescent bulbs can be purchased in a version that gives you the same light spectrum as real sunlight or daylight.  For any kind of art work, that is important when choosing yarn colors and seeing how various yarns will work together.

If you do track lighting, make sure you buy the kind of lights that can be aimed.   I had to fight with my electrician over this.  He wanted to just put in spots - and for my money they are always in the wrong place and blinding me.   Finally, when buying fixtures, not the price of the replacement bulbs.   I have some in my kitchen that cost $34 a piece to replace.   Dumb!   (Actually, that price is lower now.    Chinese imports probably.)

 

SallyE (not verified)

Halogen is too dangerous.   I refuse to have it anywhere in my house.  Even if they don't cause a fire, they are dangerous to be around because they get so hot.

Florescent bulbs can be purchased in a version that gives you the same light spectrum as real sunlight or daylight.  For any kind of art work, that is important when choosing yarn colors and seeing how various yarns will work together.

If you do track lighting, make sure you buy the kind of lights that can be aimed.   I had to fight with my electrician over this.  He wanted to just put in spots - and for my money they are always in the wrong place and blinding me.   Finally, when buying fixtures, note the price of the replacement bulbs.   I have some in my kitchen that cost $34 a piece to replace.   Dumb!   (Actually, that price is lower now.    Chinese imports probably.)

 

TheLoominary (not verified)

Hi Kellytwo, I have recently finished my small studio, and decided to go with CFL floods. They run cool, provide great light and are mounted in inexpensive gimble fittings. I am using five units with 23watts which emit about 90 watts of light each. I chose a cool white broad spectrum bulb which produces a light source closer to that of day light, giving better color accuracy. Total watts 115. Just a bit more than an 100 watt incandescent bulb to light my entire studio. All was purchased on-line for less than $150.00.Regards, Frank.

Submitted by Anonymous (not verified) on