I have purchase a 4 shaft loom that has not been used for some time and the metal heddles, which do not have any rust on them at all, do not slide across the shafts easily. What should I use to clean the shafts to let the heddles slide easily across the top and bottom shafts and not bind either top or on the bottom. I don't want to use an oil, for I am concern it might get on the theads. Any suggestions would be helpful. God Bless.

Comments

whiteoakgrandmother (not verified)

Old-fashioned baby powder which has talc in it is good for this but bad for you! I haven't tried baby powder with cornstarch in it so I don't know if it will work or not. If they are binding because the frame bars are too tight, top and bottom, you may be able to adjust the frame a little, or you may need a different size heddle.

Neshobe (not verified)

When I bought my used loom, I had the same problem.  I took the frames out and rubbed the cross bars down with 4x steel wool. It's a good idea to wear a particle mask when you do stuff like this.  Then I polished the tops with wax.  Now the heddles move easily.  I also rubbed down all the metal warp rods to clean and smooth them (those don't need waxing).  I imagine any good clear household wax would work; I just used some artists wax I have on hand. 

Claudia Segal (not verified)

I had a similar problem when I brought home an older model baby wolf.  I used fine sand paper on the metal rods and then rubbed the metal rods with an old candle (wax as Neshobe suggested).

Claudia

TNWEAVE (not verified)

Thanks for the tip, will give it a try, the wax is a good idea. TNWEAVE

Submitted by Anonymous (not verified) on