I purchased an artcraft loom on ebay a few weeks ago, and started test weaving it. The beat is uneven and at first I thought it was me, but I've tried several different techniques of beating and the results are the same. it appears the beater may be a little faulty beating the left side more than the right. This is the table loom structo 600. Has anyone else encountered this problem, and if so how did you fix it?    

 

thanks,

Marilyn

Comments

crosstownshuttler (not verified)

Hi Marilyn,

Could you post 2 or 3 pictures so we can see? It will make it easier to help.

Carie

debmcclintock

Sometimes when you are making friends with a loom the bar that holds the warp sometimes can wander.  Check and see if that bar has hung up in the front or the back of your loom on the left hand of the warp or cloth beam.  That would cause your warp to wind forward crooked and can appear to make your beat crooked.  This can happen on a new loom as you are checking so many other places that you don't catch that simple oops.

whiteoakgrandmother (not verified)

Hi Marilyn, The smaller the loom, the more very small problems of alignment will affect the weaving. Some additional things you might want to check are: Check the holes that the beater bolts go through for wear. You may need to add a "bushing" if one of the bolt holes is worn and loose. Check to see if the loom itself is "squarely" assembled. If you don't have a square, use a piece of paper to check it. Reassemble if need be. Check to see if the beater itself is warped by removing it and laying it on a perfectly flat surface. A picture might help, but the problem might be too small to show up. If you can identify the problem, someone here may be able to help you come up with a fix. Good luck!

mitsy (not verified)

I found out what the problem is. My warp tension was'nt even. My co-worker recommended I check the warp tension and this indeed was the problem. I fixed the tension on the warp(rewarped on the beam) and now the loom works fine.

thanks to everyone.  

Submitted by Anonymous (not verified) on